The heavy duty TH slurry pump range is designed to perform continuous pumping of highly
abrasive/dense slurries in processes from hydrocyclone feed to regrind, flotation and
tailings in minerals processing plants as well as other industrial applications.
Design Features
• Bearing assembly – a large diameter shaft
with short overhang minimizes deflection and
contributes to long bearing life. Only four
through bolts are required to hold the cartridge
type housing in the frame.
Always do your best
Above: Metal Lined, Rubber Lined, Polyurethane
Lined, Ceramic Lined is available
• Ball mill discharge
• Bottom/fly ash, lime grinding
• Coal
• Coarse sand
• Coarse tailings
• Dredging
• FGD
• Fine tailings
• Flotation
• Heavy media
• Minerals concentrate
• Mineral sands
• Ni acid slurry
• Oil sands
• Phosphoric acid
• Phosphate matrix
• Process chemical
• Pulp and paper
• Rod mill discharge
• SAG mill discharge
• Wet crushers
1. Tobee®
TH6/4D Slurry Pump
Technical Specifications
Tobee® Heavy Duty Slurry Pumps
The heavy duty TH slurry pump range is designed to perform continuous pumping of highly
abrasive/dense slurries in processes from hydrocyclone feed to regrind, flotation and
tailings in minerals processing plants as well as other industrial applications.
Design Features
• Bearing assembly – a large diameter shaft
with short overhang minimizes deflection and
contributes to long bearing life. Only four
through bolts are required to hold the cartridge
type housing in the frame.
Always do your best
Above: Metal Lined, Rubber Lined, Polyurethane
Lined, Ceramic Lined is available
• Ball mill discharge
• Bottom/fly ash, lime grinding
• Coal
• Coarse sand
• Coarse tailings
• Dredging
• FGD
• Fine tailings
• Flotation
• Heavy media
• Minerals concentrate
• Mineral sands
• Ni acid slurry
• Oil sands
• Phosphoric acid
• Phosphate matrix
• Process chemical
• Pulp and paper
• Rod mill discharge
• SAG mill discharge
• Wet crushers
• Liners – easily replaceable liners are bolted,
not glued, to the casing for positive attachment
and ease of maintenance. Hard metal liners
are completely interchangeable with pressure
moulded elastomer.
• Elastomer seal rings back all liner joints.
• Casing – Casing halves of cast or ductile iron
with external reinforcing ribs provide high
operating pressure capabilities and an extra
measure of safety.
• Impeller – front and rear shrouds have pump
out vanes that reduce recirculation and seal
contamination. Hard metal and moulded
elastomer impellers are completely
interchangeable.
• Cast in impeller threads require no inserts or
nuts. High efficiency and high head designs are
also available.
• Throatbush – wear is reduced and
maintenance simplified by the use of tapered
mating faces to allow positive accurate
alignment during assembly and simple
removal.
• One-piece frame – a very robust one-piece
frame cradles the cartridge type bearing and
shaft assembly.
• An external impeller adjustment mechanism is
provided below the bearing housing for easy
adjustment of impeller clearance.
Executive Standards
•
•
Design Standard
Hydraulic Institute 6, ISO 9001, ISO 14001,
OHSAS 18001 & CE certified.
• Castings Dimensional Standard
ISO8062
• Performance Test Standard
ISO9906, ISO2548, ISO3555
• Vibration Standard
ISO2372
• Noise Standard
ISO3746
• Hydrostatic Test Standard
ANSI/HI 1.6-2000
Material Standard
AS 2027 Grade Cr27, ISO 21988 Grade Cr27,
ASTM A532 Grade III Type A