1. PROCEDURE TO SET
FEED FRAME
Brought To You By ADEPT Engineers
Mumbai, India
www.adepttabletpress.com
http://www.facebook.com/TabletPressAdeptEngineers
2. 1. Remove the spring loaded scrapper blade and
loosen its ejection blades to set the Feed Frame.
3. 2. Place a paper between die table & Feed Frame
and fix the Feed Frame in its position.
4. 3. Loosen the Allen grub screws so that the Feed Frame knob
can move vertically. Tighten the Feed Frame knobs.
5. 4. Press the Feed Frame with one hand lightly and tighten the
Allen grub screws on both Feed Frame knobs.
5. Remove the Feed Frame and refit the scrapper blade. Replace
the Feed Frame without the paper and set the ejection blade.
6. 4. Press the Feed Frame with one hand lightly and tighten the
Allen grub screws on both Feed Frame knobs.
5. Remove the Feed Frame and refit the scrapper blade. Replace
the Feed Frame without the paper and set the ejection blade.
Editor's Notes
Hello Friends,
Today I am here to talk about the Rotary Tablet Press.
But before I begin, I must admit to you that I am not a good speaker. Hence I would prefer it to be an interactive session rather than a speech.
So at any point if you have any clarifications, questions or observations please do not hesitate to ask me right then.