2. Specifications of KTMS-3630 Ascending GPS Telesonde
Komoline Aerospace Limited
Specifications
Type of Sensing Element Resistive Bead for Temperature, Capacitive Solid-State Sensor for
Humidity, Ceramic Sensor for Pressure
Output Units
(Convertible in Receiver)
°C for Temperature, % RH, hPa for Pressure, m for altitude, m/s for
speed, ° off-N for Heading, Standard Lat-Long in °,’,”.
Typical Accuracy 0.1°C of equilibrium value for temperature, 2% for RH, 0.2 hPa for
Pressure
Resolution 0.01°C for Temperature, 0.1% for Humidity,0.1 hPa for Pressure
Range of measurement,
Temperature
-120°C to +50°C
Range of measurement,
Humidity
0 to 100% RH
Range of measurement,
Pressure
3hPa to 1100 hPa
Averaging Provision Factory Settable on Per-Parameter Basis
Electrical
Power Source Low Mass Lithium Battery Pack
Supply Current 50-100 mA (Average), 200 to 1000 mA Peak
(Depending on Transmission Options)
GPS Locking Time Cold Start, < 45s Typ
Power-On Settling Time
To Rated Accuracy
10s
Deployment
Ascent Mechanism Balloon-borne
Max Shelf Life (Calibration) 2 Years (Re-calibratable at field / prelaunch)
Max Shelf Life (Battery) 5 to 10 Years
Outputs
Type 401MHz to 406 MHz Met Band Standard
(M)FSK Radio (Settable Centre Frequency)
(Please contact Factory for Other Options)
Coding Reed Solomon FEC Coded Packets
Frequency Customizable from 400MHz to 950MHz
Sampling Frequency 1 Hz (Contact Factory for Other Possibilities)
Range 45km Vertical and 200km horizontal with KEPL Receivers
(Please Contact Factory For Other Options)
Receiver Fully Compatible Receivers Available
Measurements Free Running, 1 Hz (Customizable), GPS Time-Stamped
Baud Rate 1200 – 4800 Baud (Factory Settable)
Transmitted Power 250mW Typ, Customizable to 1W
Mechanical
Materials Low-Temperature Tolerant Materials Including HDPE and Metallic
Alloys. Styrofoam is also used.
Mass <120 g
Size 60mm x 60mm x 160 mm Body; Length Excludes a 140mm Sensor
Probe and 200mm Antenna (400MHz Band)
Calibration
Standard In-House Dedicated Calibration Facility
KTMS-3630-DS-Rev 4.3 - June 03, 2013