When it comes to network equipment, Cisco is ruling the market with its superior products. The 2960 series switch is one of those products.Following the easy way to know how to reset Cisco 2960 switch's password.
3. Why you need to reset password
• They say that you get what you pay for! In the case of the best-selling
Cisco 2960 switch, a reliable enterprise-grade Ethernet switch with a
lifetime warranty, the quality does come with a price. It makes sense for a
buyer to look around for a used model.
• When buying a used switch, you may face a problem if the seller has
forgotten to reset his password. Luckily, recovering the password on this
switch is straightforward. You can interrupt the boot sequence during the
power-on, and then assign a new password.
• However, if this functionality is disabled, you'll only be able to recover the
password by agreeing to lose your old configuration: in that case, the
system configuration will be restored to factory settings. The password
recovery process on Cisco 2960 switches will differ depending on whether
the password recovery is enabled or disabled.
4.
5. • On the other hand, you can very easily reset the
password on your Cisco 2960 switch to default.
Be aware that while rather uninvolved, the reset
procedure reverts your switch back to its factory
settings: all your settings will be wiped out, not
only the old password! This procedure only works
if you have physical access to the device. The
auto setup should be disabled.
• Find the best price on Cisco 2960 and Cisco 2960s
switches.
6. Easy way to reset password
•
First, power off your Cisco 2960 switch by unplugging its cord. As you reconnect
the switch to the power source, press and hold the "Mode" button. On Cisco 2960
switches, this button is located on the front of the switch, on the left hand side.
•
After three seconds, the LED above the button should change from amber to green
and start blinking. You are supposed to hold down the button until the light stops
flashing. Release the button.
•
Congratulations, you have just reset your Cisco 2960 switch! The password is now
set back to factory defaults.
•
Obviously, you should only use this procedure if you don't care for the current
configuration, because you'll lose your configuration in the process of password
recovery! The old configuration will get renamed ".old".
•
This reset procedure can come in handy in those cases when you need to move a
switch from one network to another, or when a configuration has become too
complex, and you'd want a fresh start.
7.
8. • The default password for Cisco 2960 switches is "cisco", and
the username is also "cisco".
• Now that you've had successfully recovered your Cisco
2960 switch password, don't leave it as a default for too
long. Hackers know these default passwords too, and may
try to use them to access your device and change your
network settings. To prevent the unauthorized access to
your network, change the default password as soon as
possible.
• Article Source: http://ezinearticles.com/?How-To-ResetYour-Cisco-2960-Switch-Password&id=8123449