Mazda Certified Pre-Owned CPO 150 Point Vehicle Inspection CardinaleWay Mazda in Mesa, AZ

  • 894 views
Uploaded on

Mazda Certified Pre-Owned CPO 150 Point Vehicle Inspection CardinaleWay Mazda in Mesa, AZ

Mazda Certified Pre-Owned CPO 150 Point Vehicle Inspection CardinaleWay Mazda in Mesa, AZ

More in: Automotive , Business
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Be the first to comment
    Be the first to like this
No Downloads

Views

Total Views
894
On Slideshare
0
From Embeds
0
Number of Embeds
0

Actions

Shares
Downloads
9
Comments
0
Likes
0

Embeds 0

No embeds

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
    No notes for slide

Transcript

  • 1. Mazda Certified Pre-owned 150-Point Vehicle Inspection VIN ________________________ I. Manuals and Documentation 26. Confirm that vehicle does not pull Engine Coolant, Air Conditioning and left or right upon braking Heating Check that following items are located in 27. Check for unusual brake noise 60. Check for proper coolant specific the glove compartment: 28. Confirm that brake pedal free play is gravity within specifications 61. Pressure test cooling system to 1. Owner’s Manual 29. Confirm parking brake sets and fully check/correct leaks 2. Warranty Manual releases 62. Check/correct cooling fan operation 3. Vehicle History Report 30. Test for master cylinder bleed down 63. Check water pump for noise and 4. Perform emissions test and/or state 31. Confirm proper operation of brake leaks inspection, if required booster 64. Confirm that coolant recovery tank 5. Verify that VIN plates match under is full to the correct level and does Steering hood, dash, and door pillar not leak 32. Test tilt steering wheel for proper 6. Check vehicle service history 65. Check hoses for cracks. Replace if operation 33. Confirm that steering has smooth needed II. Recalls feel in lock-to-lock range 66. Test A/C cooling operation 34. Check for excessive noise from 67. Confirm that A/C refrigerant sight The following recalls were required and power steering pump glass is clear performed: 35. Confirm that steering wheel is 68. Check for any indication of leakage 7. None centered in straight line driving at A/C connections 8. List recall numbers _____________ 69. Confirm normal heater operation 36. Confirm that vehicle tracks and drives straight on level surface III. Test Drive (10-15 Minutes) Battery (confirm the following) 37. Check for excessive tire vibration or steering wheel shimmy 70. Battery is correct specification for Engine: 38. Check for any unusual handling this vehicle 9. Confirm that engine is operating conditions in cornering and braking 71. Battery is secured properly and shows no obvious 39. Check for any wheel bearing noise 72. Battery posts are free of corrosion signs of damage 40. Check for unusual tire noise 73. Cables are in good condition and 10. Check that engine oil pressure is 41. Listen for any other unusual noise, properly secured within normal range vibration, or harshness 74. Battery charge is at prescribed level 11. Check that engine reaches normal operating temperature V. Raise Vehicle on Hoist 12. Confirm smooth idle speed & adjust Other test drive inspection points if necessary 42. Confirm operation of cruise control Tires, Brakes & Suspension 13. Confirm smooth acceleration 43. Check for wind noise 75. Inspect tires for damage 14. Check for any unusual noise or 44. Check speedometer and tachometer 76. Confirm tires have minimum 5/32 vibration at idle and under for proper operation inch or 50% tread remaining acceleration 45. Check for significant squeaks or 77. Set tires to proper inflation 15. Check for engine pinging rattles 78. All four tires must be of same brand, 46. Confirm that navigation system model, and size Transmission works properly 79. Check wheels for damage or major 16. For manual transmission – check 47. Check for turn signal self-cancel scratches clutch operation, smoothness, and operation 80. Check that spare tire is present and slipping IV. Under the hood at proper inflation 17. For manual transmission – check for 81. Check that jack and tools are synchronizer quality 48. Check for stored trouble codes present and functional 18. For automatic transmissions, check 49. Confirm that fuel cap is present and 82. Confirm that wheel covers and caps shift quality & shift points the proper part are all present and secured 19. For automatic transmissions, check 50. Replace Air Filter if dirty or at service 83. Replace Disc brake pads if wear is for slipping bands and clutches interval greater than 50% 20. Confirm operation of transmission 51. Replace Wiper Blades & top up 84. Replace Brake shoes if wear is shift lock and key interlock system washer fluid greater than 50% 21. Confirm that transfer case switches 52. Check belts for cracks and wear 85. Inspect struts/shocks for leaks and smoothly from 2WD to 4WD and 53. Check for engine oil leaks wear back again 54. Check for any broken or missing 86. Inspect steering rack, linkage, 22. Confirm that there is no vibration ducts, brackets, and engine covers bushings, control arms, and dust from CV joints and axles 55. Check for oil in the air cleaner boots 23. Confirm that there is no vibration 56. Check for water in the engine oil 87. Check tie rod ends, ball joints and from drive shaft on rear drive 57. Test compression if engine shows other suspension links and bushings vehicles any signs of excessive smoke, poor 88. Confirm that CV joint boots are free performance or rough idle from damage Brakes 58. Brake master cylinder and clutch 24. Check for excessive vibration during 89. Replace Engine Oil & Filter master cylinder has the correct fluid braking level 25. Confirm that ABS operates on hard 59. Power Steering reservoir is at the stops correct level (Rev. 7/08)
  • 2. Mazda Certified Pre-owned 150-Point Vehicle Inspection VIN ________________________ Drive Train 123. License plate lights I certify that the above components and 90. Inspect transmission for leaks 124. Air bag light systems have been checked and are in 91. Check for any engine oil leaks from 125. Check engine light normal operating condition. I also certify under the vehicle 126. Instrument panel lights that all outstanding recall work required on 92. Check for damage to drive and axle 127. A/C on indicator light this vehicle has been completed in shafts 128. Dash light dimmer control accordance with Mazda’s requirements. 129. Rear window defroster indicator light Frame & Underbody 130. Dome lights and interior courtesy 93. Check for frame or unibody damage lights 94. Check for rust 95. Check fuel tank and fuel lines for Vehicle Exterior (confirm the _____________________________________ damage or leaks following) Inspected by (Print technician’s name) 96. Inspect brake lines and hoses 131. No cracked or broken exterior 97. Check exhaust system and rubber lenses hangers 132. All emblems are present and in good 98. Check for presence of catalytic condition ____________________________________ converter and shielding 133. Outside rearview mirrors function Technician’s signature 99. Inspect motor mounts and and no damage to lenses transmission mounts 134. Windshield is free of cracks, large chips, and improper repairs ____________________________________ 135. Body is free of major dings Dealership Name/Number VI. Lower Vehicle 136. Bumpers are free of cuts and Body Electronics (confirm the scratches following) ____________________________________ 137. Paint is free of major scratches and 100. Horns function Date chips 101. Clock is operational 138. No evidence of mismatched paint 102. Ambient temperature displays if 139. Truck bed liner is in good condition equipped 140. Tailgate, hood, and trunk latches 103. Steering wheel controls are and hydraulic stays function properly operational 141. Convertible top functions correctly 104. All wiper speeds work correctly 142. Roof rack is secure and in good 105. Windshield washer operates condition 106. Cigarette lighter and power outlets 143. All aftermarket accessories are are operational tested 107. Power windows operate from master 144. Inappropriate aftermarket switch and all door switches accessories are removed 108. Door locks operate from the master switch and with the remote if Vehicle Interior (Inspect the equipped following) 109. Operation of child rear door locks. 145. Cup holders, ashtrays, and storage Set to unlock position compartments are present and clean 110. Power sunroof operates properly 146. Seats, carpets, floor mats, door 111. Radio, CD, cassette, and speakers panels, and headliner are free of operate stains and abnormal wear 112. Alarm system is functional 147. Seats and headrests work properly 113. Keyless remote entry is present and in all positions completely functional 148. Seatbelts have full range of 114. Rear defogger grid lines do not extension and smooth operation. show any damage No stains or wear 149. Seatbelts lock up per specification Interior/Exterior Lighting (confirm that 150. Remote hood and fuel door releases all are functional) operate normally 115. Low beam and high beam headlights 116. Check headlight aim 117. High beam indicator light 118. Turn signal lights and hazard lights 119. Taillights and brake lights 120. Fog lamps 121. Side marker lights 122. Backup lights (Rev. 7/08)