1. Stress Analysis Report
Bad modeling parameter - some faces have disappeared!: putter head.ipt
Error executing the solver.: 2011 (Build 150239000, 239)
$$msg20002$: 4/7/2011, 12:42 PM
$$msg20001$: swenson1906
Internal Error # 30:
$$msg20004$
Internal Error # 30
Author swenson1906
Internal Error: Can not use the same file for the input and the output
Part Number putter head
Designer swenson1906
Cost $0.00
Date Created 4/4/2011
Internal Error: Can not open the thermal load file.
Design Status WorkInProgress
Add-in format is not supported.
Material ABS Plastic
Density 0.0382949 lbmass/in^3
Mass 0.0621177 lbmass
Area 17.8721 in^2
Volume 1.62209 in^3
x=0.797486 in
Center of Gravity y=0.75 in
z=0.497578 in
Simulation:1
2. $$msg20005$
$$msg20006$ Static Analysis
$$msg20003$ 4/7/2011, 12:31 PM
$$msg20008$
$$msg20020$ ABS Plastic
Coordinate system is referenced but 0.0382949
The load is inconsistent with the boundary not defined lbmass/in^3
conditions $$msg20007$ 5853.41 psi
Ultimate Tensile Strength 5805.52 psi
Error opening the debug output file 419.448 ksi
Error opening the mesh file
Error processing the mesh 0.38 ul
Improper constraints, material or mesh 0.00015426 ul/f
0.559981 btu/( ft hr
Internal Error # ps_1
Not enough memory to continue operation f)
1.16129 btu/(
Internal Error # ps_2
lbmass f )
Internal Error # ps_3 putter head.ipt
Load not defined
Force:1
Internal solver error. Can not process the contacts. Force
Vector X 0.000 lbforce
Vector Y 0.000 lbforce
Vector Z -75.000 lbforce
Some rigid body modes remain after application of constraints
6. Unacceptable combination of boundary condition and element type
Can not open the pre-stress file
Mesh at the contacts is too coarse. It is
Improper preloading recommended to use local mesh control in the areas
Error of high stress concentration.
reading
the pre- The assembly
Internal The assembly
stress file breaks up into
Error # breaks up into $$msg20064$$$GroupReaction$
disjointed
100 disjointed pieces
pieces
Internal Error # 101
$$msg20020$ Internal Error # 201 Internal Error # 202
$$msg20091$
H:PLTWGolf ProjectInventorputter head.ipt