Clean the screen thoroughly using a cleaning cloth or moistened tissue to remove any dust or dirt. Align and apply the screen protector, peeling labels 1 and 2 to adhere it to the screen. The instructions provide steps for accurate installation and troubleshooting tips if the protector does not stick correctly on the first try.

3.  youshould line up
the screen
protector and
make sure that
every things fit.
Our films are cut accurately for easier
installation

6. Clean the screen using the cleaning cloth or a wet tissue , if tissue
is too dry you can use a drop of water to make sure its moisten.
Wet Tissue Cleaning Cloth

7.  Dustand dirt is the
No.1 cause for
bubbles appearing
underneath, so
ensure the screen
is completely
clean.

8. Once the screen is clean..

9.  Peel the label mark
No.1, this is the side
that goes on to the
screen,
Avoid touching the back of the screen protector to avoid
fingerprints,

10.  Alignthe screen protector while you do
the installation.

11.  Just peel of the label mark
no.2 and
You are done.

13. Don’t worry.,

14.  firstpeal back the screen protector, use the
piece of sticking tape and tap on the dust, on
the screen and on the screen
protector, unless fully free from dust.

16.  If the film doesn't not sticks from the Label No.1
direction, try sticking the Screen Protector from the Label
No.2 direction.
 Rarely No.1 Label may be placed on the No.2 side, and to
avoid wastage, film can be examined by inspection it’s
surface on the screen.

17. For Further Queries Contact :
Aashish Kumbhat
+91 9840203040
aashish@inbasetech.com