The document provides assembly instructions for a Storz ETO valve cap. It instructs the user to apply epoxy to internal threads, thread a bulb pin into the main body until fully seated, clean off excess epoxy, coat an O-ring in grease and install it, and pressure test the assembled parts to ensure no leaks under water submersion.

1. 2
1
3
A
A
SECTION A-A
SCALE 4 : 1
O-Ring Location Inside I.D. Groove
Apply Loctite M-31CL Hysol 2:1 Epoxy to ID threads1.
Thread Item No. 2 into P/N 1 - ensure the part bottoms out2.
Clean excess glue from outside/inside and all holes3.
After glue is cured coat P/N 3 in clear silicon grease, clean off excess and install to O-ring groove4.
All assemblies must be pressure tested to 230-240 mmHg (4.5 psi) and submerged in water5.
minimum 1 minute with no sign of pressure leakage
ITEM NO. PART NUMBER DESCRIPTION QTY.
1 STETOVC01-BODY Main Body 1
2 STETOVC01-BULB Threaded Bulb Pin 1
3 728006 O-Ring 1
D
C
B
AA
B
C
D
1234678
8 7 6 5 4 3 2 1
NEXT ASSY USED ON
APPLICATION
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 1/64
ANGULAR: MACH 1.00°
ONE PLACE DECIMAL 0.1
TWO PLACE DECIMAL 0.01
THREE PLACE DECIMAL 0.002
INTERPRET GEOMETRIC
TOLERANCE PER: ASME Y14.5-2009
MATERIAL
FINISH
DRAWN
CHECKED
ENG APPR.
MFG APPR.
Q.A.
COMMENTS:
Assembly redrawn for file purposes only
DATENAME
TITLE:
SIZE
B
DWG. NO. REV
WEIGHT:SCALE: 4:1
UNLESS OTHERWISE SPECIFIED:
D
LJM 05/28/14
Storz ETO Valve Cap
SHEET 1 OF 1
STETOVC01
DO NOT SCALE DRAWING