1. Unpack the plyometric box pieces and hardware from the shipping box. 2. Identify the bottom piece and side pieces, attaching one side with a single screw to start. 3. Add the remaining sides one by one, installing screws as you go, until the box frame is assembled. Then add the center support structure and top piece, installing all remaining screws.

1. Plyo
Box
Assembly
Instructions
http://www.garagegym.net/garage-­‐gym-­‐equipment/mobility-­‐tools/plyometric-­‐
box-­‐20x24x30-­‐wood/
General:
We
recommend
using
a
dollop
of
Gorilla
Clue
with
each
screw
the
most
secure
installation.
We
recommend
using
an
electric
screw
driver
if
available.
Important
–
use
the
correct
size
Phillips
head
driver
to
avoid
stripping
the
screws.
Not
all
phillps
head
screw
drivers
are
the
same.
1. Unpack
your
plyo
box
from
the
plywood
box
that
it
came
in.
It
should
look
like
this:
2. Remove
the
plyo
box
from
the
packing.
You
should
have
the
9
wood
pieces
and
a
packet
of
screws.
3. Start
by
identifying
the
bottom
(the
one
of
the
two
largest
pieces
without
the
Garage
Fit
Logo
on
it)
and
placing
the
finished
side
down,
connect
one
of
the
sides
to
the
base
and
install
the
one
screw
on
the
side
that
will
connect
the

2. two
pieces.
Provided
you
don’t
start
moving
the
base,
this
should
remain
secure.
4. Install
the
second
side.
Install
2
screws.
One
at
the
floor
and
center
screw
connecting
the
two
side
pieces.
(We
install
the
remaining
screws
when
all
sides
are
assembled).

3.
5. Repeat
step
4
for
the
third
side
6. Install
the
4th
side
and
install
3
screws.
The
center
screw
on
each
side
and
the
one
at
the
center
on
the
bottom.

4. 7. Press
together
the
two
center
support
structure
pieces.
8. Screw
on
the
third
support
piece
to
the
center
structure

5. 9. Place
the
center
structure
inside
the
plyo
box
structure
10.Place
the
top
on
the
structure
and
install
all
screws
on
the
top
11.Rotate
the
plyo
box
and
install
all
remaining
screws