The document provides instructions for inspecting and disassembling/assembling torque converters for backhoe loaders. It describes inspecting the converter hub splines and welds for wear or damage, and replacing the converter or drive plate if issues are found. The disassembly process involves removing the drive plate screws and plates and then the converter. Reassembly requires installing the converter on the input shaft, then the drive plates with screws tightened to a specified torque.

1. www.newhollandconstruction.com
SERVICE
MANUAL
BACKHOE LOADER
Issued 04-2006
60367230 NA
B95
B95TC
B95LR
B110
B115

21. SECTION 17 - TORQUE CONVERTERS 9
2.4 INSPECTION
Inspect the splines on the converter hub for wear or
damage and the weld joints for cracks. If the hub is
worn or damaged and/or the weld joints cracked, a
new converter must be installed. A new drive plate
should also be installed if it is warped.
2.5 DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
Remove drive plate screws.
Remove drive plates.
Remove torque converter.

22. 10 SECTION 17 - TORQUE CONVERTERS
ASSEMBLY
Install converter assembly on input shaft.
Install drive plates on converter.
Install drive plates screws and lock washers and
tighten screws to specified torque 43 Nm (32 lfb·ft).

25. Thank you very much for
your reading. Please Click
Here. Then Get COMPLETE
MANUAL. NO WAITING
NOTE:
If there is no response to
click on the link above,
please download the PDF
document first and then
click on it.