The document provides a step-by-step guide on creating a simple motor using common materials such as copper nails, electrical tape, and a battery. It outlines the necessary tools and instructions to build the motor, including preparation of clips and wiring. The goal is to demonstrate basic electromagnetism through the functioning of the motor.

1. creaTing a SiMPle MoTor
PrePared by: Melchor cariño
b.S.i.T(icT)
iTfndS1 Thu 11:30 – 2:00

2. brief deScriPTion
creaTing a SiMPle MoTor iS juST SiMPle.

3. MaTerialS
Two 3 and Copper nails
●●Insulated 1/2 inch
● Electrical Tape
Paper Clip Plier
Thumb Tacks
Long-Nose
● ●
●
Wood Cutter, or Scissor
Knife,
●●
Battery
●

4. STeP 1
Get two of the clips Bend each clip using the long-
nose Pliers
This is the Process

5. STeP2
Place the 2 the first tacks a
Place second clip with
Place thumb clip
distance of 1 inch

6. STeP 3
Use the insulatedends toto
Wrap Bend both copperon
Use the knife or cutter
the electrical tape
Cut both endsthird clip
Get the of the copper
both ends asclip tightly
remove the insulator
wind the shown below
Perpendicularly
20 turns
20 turns

7. STeP 4
Remove thenail with wire 6 inch
Wrap each Insulator using knife
Wrap each nail leaving leaving
Get the two Nails
going up to the middle
aboutor inch of wire
9 cutter

8. STeP 5
Get theHammer it down nails
two electromagnet
Put the rotor clip
and put it beside the arrow
shown below

9. STeP 6
ThePutConnect tackswill be left
the wire that are
2 connectionsandon it
Put thumb C thatB
Connect A D
will serve as + the rotor clip
connected to and – for the
battery A
B
C D
-
+

10. ouTcoMe