The document describes the components of an experimental setup including a 6mm diameter rod, teflon piece, and seal connected to a branch fitting. A 6mm diameter probe stem mounts to a mounting board along with a size 14 linear actuator manufactured by Haydon Kerk to move the probe stem. Spacers are used to provide a 2 inch length between the mounting board and the actuator.

1. Test Section of the
Experimental Setup
Branch fitting
Teflon piece
6 mm diam rod
seal
4x 1/4" hex male-female
standoff (aka spacers)
Spacer Length: 2 inches
6 mm diam probe
stem
mounting board to
hold actuator
size 14 captive
linear actuator
(Manufactured by
Haydon Kerk)

2. A A
B B
C C
D D
E E
F F
8
8
7
7
6
6
5
5
4
4
3
3
2
2
1
1
DRAWN
CHK'D
APPV'D
MFG
Q.A
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
FINISH: DEBURR AND
BREAK SHARP
EDGES
NAME SIGNATURE DATE
MATERIAL:
DO NOT SCALE DRAWING REVISION
TITLE:
DWG NO.
SCALE:1:1 SHEET 1 OF 1
A3
WEIGHT:
traverse_system_assembly