Epoxy floors Ohio are commonly used in industrial and commercial flooring. Epoxy Floor Ohio is normally applied on top of concrete creating a high-performance, durable and smooth surface that can withstand heavy loads and last for many years

3. Epoxy floors Ohio are commonly used in
industrial and commercial flooring. Epoxy
Floor Ohio is normally applied on top of
concrete creating a high-performance,
durable and smooth surface that can
withstand heavy loads and last for many
years. Many industrial facilities,
warehouses, as well as commercial
buildings, depend on epoxy floors Ohio
because they are easy to clean and are
safe for workers, inventory and
equipment.

6. • Before you apply the coating,
make sure that the concrete surface
is clean and semi-porous. It cannot
bond on a covered or concrete which
is polished. You must make sure that
the concrete is fully cured and make
sure that you search and repair
holes which are on the concrete
surface. Also, you have to remove
any available grease and oil.

9. • In case that the concrete is old, conduct
testing on the concrete surface to identify any
previous layer covering the concrete surface. You
can do this by pouring water on the floor. If the floor
does not absorb that water, then it is likely that the
concrete is sealed and that means it is not suitable
for epoxy floor Ohio coating.
• Also, you have to make sure that the room
temperature as recommended by the manufacturer.
The unfavorable temperature will make the coating
to bubble and peel. Epoxy is a mixture of liquid and
other chemicals and after the mixture, your time is
limited, so you have to apply it quickly before it
becomes stiff and hard.

12. It depends on the type of product that you
are using; you might have to use an
epoxy primer and finisher coat. You will
add the primer just like normal paint, and
you have to allow it to dry for several
hours before applying the epoxy. In order
to apply the primer, you have to cover the
floor with a thin layer of water and then
spread the primer evenly using a roller
pin on a pole evenly on an entire floor.
Apply the finisher using the same
formula.