1. 1A
Fail-Safe Table
When any of the following DTCs is detected, ECM enters fail-safe mode as long as
malfunction continues to exist but that mode is canceled when ECM detects normal
condition.
DTC DTC name Fail-safe operation
P0031
HO2S Heater Control Circuit Low
—
P0032
HO2S Heater Control Circuit High
P0107
Manifold Absolute
Pressure/Barometric Pressure Circuit
Low ECM presumes manifold absolute pressure
/ barometric pressure.
P0108
Manifold Absolute
Pressure/Barometric Pressure Circuit
High
P0112
Intake Air Temperature Sensor1
Circuit Low
•ECM controls engine assuming that intake
air temperature is 20 °C (68 °F).
•ECM stops A/F feedback (closed-loop)
control.
•ECM stops ISC feedback control.
P0113
Intake Air Temperature Sensor1
Circuit High
P0117
Engine Coolant Temperature Sensor1
Circuit Low
•ECM controls engine assuming that
engine coolant temperature is 80 °C (176
°F).
•ECM operates radiator cooling fan.
•ECM stops A/C control.
•ECM stops A/F feedback (closed-loop)
control.
•ECM stops ISC feedback control.
P0118
Engine Coolant Temperature Sensor1
Circuit High
P0122
Throttle/Pedal Position Sensor/Switch
“A” Circuit Low
•ECM controls engine assuming that
throttle opening angle is about 20°.
•ECM stops A/F feedback (closed-loop)
control.
P0123
Throttle/Pedal Position Sensor/Switch
“A” Circuit High
P0130
O2 Sensor Circuit
ECM stops EVAP canister purge valve
control.
P0327
Knock Sensor1 Circuit Low
•ECM stops knock control.
•Ignition P0328 timing is retarded.
Knock Sensor1 Circuit High
P0335
Crankshaft Position Sensor “A” Circuit
—
P0336
Crankshaft Position Sensor “A” Circuit
Range/Performance
P0340
Camshaft Position Sensor “A” Circuit
ECM performs fuel cut at 4,000 rpm.
P0341 Camshaft Position Sensor “A” Circuit

2. Range/Performance
P0443
Evaporative Emission System Purge
Control Valve Circuit
—
P0480
Fan 1 Control Circuit
P0500
Vehicle Speed Sensor “A”
•ECM controls engine assuming that
vehicle speed is 0 km/h (0 mph).
•ECM stops ISC feedback control.
P0505
Idle Air Control System —
P0601
Internal Control Module Memory
Check Sum Error
—
P0602
Control Module Programming Error
P0616
Starter Relay Circuit Low
P0617
Starter Relay Circuit High