1. The best ways to Lay Laminate floors
The following tutorial gives step by step instructions on the way to lay your wood flooring. I
suggest you first verify which sub-floor you intend to fit your laminate floor onto since
individual floorings are certainly not designed for every sort of sub-floor.
Installing wood flooring on screed
The surface should be absolutely level, dried up, clean as well as firm. It is very important to
sand down and top off any unevenness higher than three millimetres over 1 metre. You'll
want to use a moisture barrier.
Fitting wood flooring on wooden boards
Loose floorboards have to be fixed and bumpy floors is required to be smoothed off to ensure
a flat, firm surface area to install on. Fit the laminate kitchen floors at right-angles to the
lengthwise path of the timber planks. May very well not make use of PE foil on timber subfloors.
Laminate flooring on wooden boards
Loose wooden boards have got to be remedied and also any unevenness levelled out. The
planks will need to be properly connected to the sub-floor so that there is no creaking
afterward.
Putting in laminate on Pvc material or linoleum floorings
These kinds of old flooring must be taken out.
A floor temp of 25 degrees Celsius is advisable; you should never go beyond 28 degrees
Celsius. Old flooring surfaces should be taken away.
Passive moisture content
The screed dont want to exceed the subsequent residual dampness values:
1.) Bare concrete screed: With under floor heating 1.8 percent CM; without under floor
heating Two pct CM.
2.) Anhydride screed: With underfloor heating 0.3 p.c; without under floor heating 0.5 per
cent CM.
Ahead of fitting your laminate kitchen floors please be sure you move through these
checklists.

2. A.) Tools check-list
You should have the following resources ready to hand all the time when installing your
laminate floors:
• Spacer wedges
• Circular saw, Jigsaw or handsaw that has a finetooth
• Angle for undercutting the doorframes
• Tapemeasure, pencil
• Laminate fitting kit
• Tapping block, Hammer
• Acoustic sound underlay (for floorings without a Sound Absorb System)
B.) Materials & accessories checklist
• Precise measurements of your respective room
• Laminate floor
• Clickseal one tube is enough for ten square metres of laminate floor
• Skirting boards - Wood, PVC or MDF with real wood veneer
• Scotia or quadrant beading transition and edge profiles
• Fixing clips (30 clips per pack of flooring)
• Vapour barrier layer, Gold/Silver dune underlay
• Foam underlay
Please also be aware that supplemental transmitted audio insulation is vital for laminate
floorings without S.A.S (Sound Absorb System). Under specific situations you may need a
joint seal, joint sealing substance and glue/bonding agent.
Just before fitting: Store the packs of flooring for Two days in the same climatic conditions as
for fitting.
A crucial necessity for set up and long durability of the laminate floor will be a room
environment of approximately 20° Celsius and then a relative humidness of fifty to seventy
%. The sub-floor needs to be completely level, dry, clean and firm.
When fitting on the mineral sub-floor which includes concrete floor, cement screed, anhydride
screed or natural stone tiles you've got to evaluate the humidity initially. The screed ought not
to go above and beyond the following residual moisture values:
check these out, carpet underlay, wood flooring