The engine block heater is used to reduce the stress on the engine of your car in cold weather conditions. They help to keep the coolant warm for easy movement in the engine. You can easily install a heater in the car by following the steps like jack up the car, drain the engine, and route the power cord. In order to know more details on how to install the engine block heater in your car, see the following slides.

2. The engine block heater of
your car are used to reduce
the stress on your engine
during the cold weather.

3. The heater warms up the oil or
coolant of the engine and makes
them much easier to start a cold
engine. It can improve the fuel
economy in winter.

4. Thus, the electric heaters of
your car allows the engine to
reach their desired
temperature much more
quickly.

5. Several kinds of engine heater
are available in the market, that
will depend on the make and
model of the car and its
mechanical abilities.

6. Here consider the
installation procedures of
engine block heater to start
your car in cold weather.

8. The warm engine of your car
make it slightly easier to remove
the drain plugs if they are made
from different metals than the
engine block.

9. If you want to handle a cold
car then it will protect you
from burning. So, choose
the one that you are
comfortable with.

10. So select the one that meets your
needs and compatible with the car.
Then jack up the front end of the
car and remove the plastic engine
covers.

12. You can refer your owner's manual
for getting the specific instructions
about the equipment required for
installing the engine block heater.

13. Remove the clips that can hold the
radiator cover and the bolts that
can hold the radiator mounting
bracket.

14. Slide a pan under the engine and
pull out the specified drain plug at
the end of the engine block. Then
remove the radiator cap to
accelerate drainage.

16. Pre-fit the connections between the
heating rods and the power cords.
Then drop the male end of the cord
into the engine department.

17. Pre-fit the connections between the
heating rods and the power cords.
Then drop the male end of the cord
into the engine department.

18. If the trapped air is present
resistance, then displace it with
more grease. Thus, the metal clip
should be facing the rear of the car.

20. At last plug the cord into the rod,
then run the wire harness through
the engine compartments just out
of the front grill.

21. Don't move the car parts or the
hoses and follow the included
direction for improvising the
installation process.

22. Once you place the cord in the
correct position, secure it with wire
ties. To keep the cord of the engine
manifold doesn't leave the slack
behind the first tie.

24. By following the above-mentioned
points, you can easily install the
engine block heater of your car.

25. Now you have a car that will
provide more fuel efficient in cold
weathers.

26. THANK YOU!
https://sbautowerks.com/
https://twitter.com/hashtag/SantaBarbaraAuto
Repair?src=hash
https://www.facebook.com/Santa-Barbara-
Autowerks-Inc-455768191174331/
https://www.instagram.com/sbautowerks
/