Husqvarna 345 fxt brushcutter trimmer service repair manual
Using jump Leads Safely
1. Using jump Leads Safely
Unless you know what you're doing, delving under the bonnet to test with regard to or even right
faults can be dangerous. We generally recommend that you seek skilled assistance.
Check the car handbook before using leap leads. Most include general information on jump-starting
however, many consist of model specific procedures. If this is the case you must follow the
manufacturer's procedure rather than the actions described below.
Jump beginning any vehicle could be considered a safe procedure nevertheless along with damage
may be avoided if a couple of straightforward rules tend to be followed:
Keep metal objects out of just how – rings, watch straps, hand tools, clips or even stray wires just
brushing a battery publish may cause the spark, potentially exploding the actual battery and also
releasing the particular acid.
Avoid smoking or naked flames – batteries give off flammable gases therefore an explosion could
result.
Keep hands well away and prevent loose installing clothing, especially scarves or perhaps neckties –
using the engine operating it's simple to find caught-up as well as severely injured in relocating
parts just like pulleys or even belts.
Before connecting virtually any leads guarantee the vehicles are the same voltage and also which
they're parked with their handbrakes about along with ignition off. Your vehicles should never touch
as this may cause sparks or maybe an explosion.
Use your red leap lead to connect your positive terminal with the donor vehicle's great battery for
the positive terminal in the flat battery.
Then utilize the black cause connect your negative terminal involving the nice battery for you to the
right earthing point about the engine or even chassis associated with another vehicle. This particular
2. earthing point should be away in the battery along with gas system.
With both leads connected wait around three minutes for your voltages in order to equalise just
before starting possibly engine.
Start the engine in the donor car and allow it to operate for a minute.
With the particular donor automobile motor nonetheless running, commence the actual engine
associated with the other vehicle by leaving each running in a fast idle pertaining to ten minutes.
Don't eliminate the leap leads while the engines are generally running as this can trigger severe
damage towards the electronics about possibly car.
If the particular jump leads acquire hot swap off each engines and allow the particular leads to cool
for you to steer clear of any achievable fire.
Turn off the particular ignition upon each cars then disconnect the particular leads carefully inside
the reverse order for the way that these folks were connected. End Up Being cautious not to touch
the actual clips against one another as well as against the vehicle bodywork.
Start the automobile which had the particular dead battery using its own battery power. If it's not
really going to start this could indicate a more significant difficulty with the charging/ignition system
that will will be needing investigating with a professional.