Most of us believe that insulating certain http://nonchalantdye6855.deviantart.com/status/1460285 pa...

1. Tips on Garage Door Insulation
Most of us believe that insulating certain http://nonchalantdye6855.deviantart.com/status/1460285
parts of the house namely the garage door is an unnecessary luxury. People who have done so may
have a completely different opinion on this matter. The reasons may be due to the several
advantages provided by this process. It obstructs noise disturbances coming from the external
vicinity and may even serve as an extra protective padding for the door, increasing its durability.
This in effect improves the efficiency of the door. As a result, during the winter, the warm air
produced by the heater stays inside the house, whereas in the summer the air will be much cooler.
In this way, the expense on energy is substantially reduced. Insulation can keep away moisture and
infestation of insects from the house.
Tips on Selecting Right Insulation
The material used for the purpose of insulation varies. You can either use garage door insulation kits
or foam sheathing insulating material. Another alternative is reflective foil insulation that comes in
the form of a thin sheet, which has a reflective foil attached to its back. The efficiency of the
insulation is determined by its R value. It's sectioned into grades of high, medium, and low. When
the R value is high, it provides better thermal efficiency. If the rating for the R value is of a mediocre
quality temperature and noise regulation is reduced by the extent proportionate to it. An R value of a
low range would be of lesser quality.
How to Insulate a Garage Door
The material purchased is maintained in a compressed state. Before opening the package take the
different dimensional measurements of the door and the floor to understand the quantity of material
needed for the work of insulation. The bought product is either polystyrene foam or polyurethane
foam sheets. Instructions for fixing it to a door panel are given below.
Take the polyurethane foam sheets and cut it as per the measurements of the door panels. Use a
putty knife to tuck the foam along the panels of the garage door. Cover up the foam with the help of
aluminum foil tap. Alternatively, a stiffer quality of this material can also be opted for. You have to
cut them and attach to the door panels with glue. Fix the foam with panel brackets to secure them
further.
Weather strips is another excellent option. These are available with several specifications suited for
different purposes. Pressure-sensitive adhesive-backed foam is quite cheap and easiest to install on a
door. It is reinforced with rubber and
http://www.garagedoorseattle.com/services/garage-door-repair/ plastic coating, which raises its
efficiency. They are available in rolls and of varying lengths and thickness. When the
http://www.allprodoor.com/ strips are fit to the door, it provides a padding effect which reduces
noise on account of slamming. The durability of this material lasts up to three years. Here are the
instructions for its usage:
Remove the back layer of the strip and paste it on the garage door.
Apply adequate pressure so that
it adjusts well to the door surface. If required, you can put some nails to fix it tightly.
In case you
are opting for a kit, refer to the instruction manual provided by the manufacturer.
Finally, check if
the compression bubble at the bottom of the door or the weather stripping at the sides of the door
are in good condition. If not, then replace them with new ones to get a better result. After the work

2. is completed, inspect it or have a building expert look over it.
Wear a protective gear while handling the weather strips or the foam sheets. Direct contact with this
material can cause severe itching. Keep your skin covered using gloves, boots, goggles, and mast
while working.
http://www.buzzle.com/articles/insulating-garage-doors-tips-on-garage-door-insulation.html