This syllabus outlines the design and simulation of various electronic circuits in a lab course, including feedback amplifiers, oscillators, tuned amplifiers, signal processing circuits, and multivibrators. Students will design these circuits and simulate differential amplifiers, filters, multivibrators, converters, multipliers and logic gates using PSPICE software to analyze magnitude and phase response.

1. Syllabus –(2013-2014-Even sem)
EC 2257 ELECTRONICS CIRCUITS II AND SIMULATION LAB L T P C
0032
DESIGN OF FOLLOWING CIRCUITS
1. Series and Shunt feedback amplifiers:
2. Frequency response, Input and output impedance calculation
3. RC Phase shift oscillator, Wien Bridge Oscillator
4. Hartley Oscillator, Colpitts Oscillator
5. Tuned Class C Amplifier
6. Integrators, Differentiators, Clippers and Clampers
7. Astable, Monostable and Bistable multivibrators
SIMULATION USING PSPICE:
1. Differential amplifier
2. Active filters : Butterworth 2nd order LPF, HPF (Magnitude & Phase Response)
3. Astable, Monostable and Bistable multivibrator - Transistor bias
4. D/A and A/D converters (Successive approximation)
5. Analog multiplier
6. CMOS Inverter, NAND and NOR