2. Fitting Guidelines:
• Model foot analysis and Process Approval:
• Initial foot evaluation will be performed with model standing,
• General assessment will include:
• Toe length – Size Length – Ball girth – Waist – Instep
• Calf and ankle heel with general analysis of arch.
• If measurement are 3 mm +/- than Fit Flop Standard the
• Model will be performed in the next day.
• If approved, Model will be entered in Fit Flop model
• Library.
3. The foot and The Last
• The Shoe Last Measures should be accordingly with our Foot Model
Standard
• In the illustration we can see a better view and the most used measure
points in the Foot and in the Last.
4. Fitting Preparation:
• Fitting session must take place between 11:00am until 3:00pm to ensure
foot is ideal for fit testing.
• Model will be measured standing and wearing appropriate hosiery
• Measurement taken with Brannock or taped prior to fitting session, if
model is 3mm below or above the standard, fit session will be
• Suspended until fitting girl are in right measure.
• Be sure to stand, not sit, when
• Take the measurement
5. Fitting analysis and Approval:
• Approval of Model Fit will consist of the following points:
• Fitting location and procedures followed as instructed
• All fitting assessments will be performed while model is standing and
repeat again after walking a minimum of 10 paces (steps)
• Model and Technical will fill all points indicated on the Fit Test Report.