Folding ChairsThe Folding Chair Rack provides you to get those chairs up along the wall and off the floor. This ChairRack ...
Cut 2 inches from each side of the longer board starting 15 inches from one end and extending allthe way to the other end....
Upcoming SlideShare
Loading in …5
×

Folding chairs

168 views

Published on

Published in: Business
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
168
On SlideShare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
Downloads
2
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Folding chairs

  1. 1. Folding ChairsThe Folding Chair Rack provides you to get those chairs up along the wall and off the floor. This ChairRack is the best way to store folding chairs and can be installed in just 15 minutes. Reclaim yourstorage space today. The Folding Chair Rack kit is planned to consolidate chairs using less space. Thechairs can be slid without removing them from the hook, so you can easily move them a little to theleft or right. The folding chair rack can hold eight to ten folding chairs. This Chair rack is ideal forgarden chair, camping chairs, terrace chairs and folding chairs.How to Make a Folding ChairUse your carpenters saw to cut the board into 2 pieces--a longer piece that is 51 inches long and ashorter piece that is 40 inches long.
  2. 2. Cut 2 inches from each side of the longer board starting 15 inches from one end and extending allthe way to the other end. The solution should be a board that is 15 by 11 inches and then 7 by 36inches. This piece will make the seat and the back leg, or support, for the folding chair.Trace the thinned end of the longer board in the center of the shorter board 15 1/2 inches from oneend. Find the center of the board that will be copied onto and the center of the board to be copiedand line up these 2 points before tracing.Drill a hole inside the surface area that you just traced so that your fretsaw can fit inside this area tocut it out.Cut out the slot that you just traced applying your jigsaw, making a point to cut away enough so youcan slide the thinned end of the longer board through at an angle.Slide the 2 boards together and try your chair out.Redefine the angle of the seat plank. Since the boards wont intersect at a right angle, you require tocut the back part of the seat where it rests against the other board so the 2 boards can rest flushagainst one another. To accomplish this, draw a line from the upper corner of the side edge of theseat downward. The line should run parallel with the back of the chair.Cut this small wedge of wood from each side of the back of your chairs seat so that the seat can nowrest flush again the back of your chair.http://furniture.furkey.com/en-US/folding-chairs/1496-folding-chairs.html

×