Select a decent area for putting your flagpole, check and ensure there are no electrical cables above or subterranean.

1. Burrow a gap 12" in breadth and 26" profound, utilizing the size of a commonplace post opening
digger, in firm or substantial soil. An enormous gap might be vital in free or sandy soil. Spot the
pea rock or rock in the base of the gap and level to a profundity of around 4". The pea rock or
rock of flagpole climber will help with waste.
Introduce the 2 1/4" stop fastener in the ground sleeve with the nut on the opposite side of the
screw. Fix nut so the fastener isn't damping down excessively close on the ground sleeve. Spot
ground sleeve in the focal point of the opening and lay the level on the ground over the gap close
to the ground sleeve. You with flagpole climber ought to have 1" of the ground sleeve over the
ground level. If not eliminate ground sleeve and include or eliminate pea rock or rock varying to
get the 1" estimation over the ground level. (We have known about people that they have the

2. head of the ground sleeve level with the ground so they can eliminate the post and go over it with
their yard trimmer).
Wedge 4-5 medium size rocks between the ground sleeve and the side of the dividers. This will
additionally make sure about the ground sleeve after the concrete has dried into the opening.
Empty cement into blending holder and afterward blend as coordinated. Have your associate
hold the flagpole in the focal point of the gap and utilize the level to check the flagpole's
arrangement. Presently empty the solid into the opening and ensure that it will slide through the
stones and right to the base of the gap. Head of the concrete will be around 2" roar ground level.
Check two areas on the flagpole climbing shaft 90 degrees separated with the level to safeguard
the post is straight all over. Permit cement to set before eliminating post starting from the earliest
stage.
Let concrete solidify as per the production's prerequisites. We suggest setting an admonition
banner or some item by the ground sleeve. This will shield the ground sleeve from being upset
just as wipe out the odds of individual injury while the concrete solidifies. Permit at any rate 24
hours for the concrete to solidify before you can raise the flagpole at its most elevated position of
flagpole climbing.
Note: An elective method to make sure about the ground sleeve in sandy soil is to solidify the
sleeve in a five gallon basin and burry the pail into a bigger opening in the ground as above.
After the shaft is in the ground sleeve, utilize the hex-key to bolt the two set screws (included) at
the head of the ground sleeve to help forestall vibration and burglary. You may likewise put a
little cushion lock (not gave) through the base part of the last catch to help hinder burglary.