Removing and installing headlight

1. Removing and installing headlight
Removing
– Screw out bolts -1-.
Guide a long spanner -3- through
the recess and screw out securing
–
bolt at bottom of headlight housing -
2-.
Note
Use a magnet if necessary for
detaching the bolt.
Turn outer edge of headlight
inwards behind wing -arrow 1- and
–
pull headlight out of pin in centre
area of vehicle -arrow 2-.
– Unplug connector.
– Detach headlight.
Installing
Install in reverse order, paying
attention to the following:
Following headlight replacement:
Measure and note down dimension
– -a- between plastic bolt and
headlight housing on old headlight.
On new headlight, set plastic bolt
– with respect to headlight housing in
line with dimension -a- noted down.

2. All models:
Insert outer edge of headlight on
–
inner side behind wing -arrow 1-.
Insert pivot pin of headlight in guide
–
in centre area of vehicle -arrow 2-.
Align headlight with body contours
–
(shut lines).
Note
Pay attention to the area at the wing
opening when aligning the headlight.
– Tighten bolts.
Following installation, adjust
–
headlights → Booklet402.
Tightening torque
Component Nm
Headlight to lock carrier 6