1. GENBA SOPANRAO MOZE TRUST'S
GENBA SOPANRAO MOZE COLLEGE OF ENGINEERING,
BALEWADI
Seminar on
“Stress Analysis of Eccentric Gear with
Asymmetrical Profile of Teeth”
Under guidance of,
Prof. V.U.Mane sir
Presented by,
Sachin Yadagudi
Roll No- 59
2. Objective
stress calculated in a standard way according to
available formulas is approximate because some
impacts cannot be determined with sufficient
accuracy.
The problem is solved for elliptical, eccentric gear
with asymmetrical profile of tooth.
3. Inroduction
• The stress calculation of this non-standard
gearing is very complex
• Comparative stress
• The complicated shape of the teeth is the
determination of stress in the teeth difficult
• stress examining in a section of the foot tooth
with asymmetrical profile
4. Literature Review
Stress analysis of eccentric gear asymmetrical
profil of teeth
American journal of mechanical engineering volume-04
(Peter Frankovský)
geometric design of involute spur gear drives
symmetric &asymmetric teeth
Iternational Journal Of Mechanical Science
(ognyan alipieve)
6. Gear with Asymmetrical Profile of
Tooth
• Noncircular gear with
variable transmission
• Module= 3.75 mm
• Changing gear ratio for
analysis
• Ellipse formed with the
basic parameters
8. Analysis of Gears
• Mesh generated elliptical
gear, speed varies in u=0.5
through u=1.0 until u=2.0
and back
• Drive wheel gear speed is
constant
• Continuous changing of the
gear ratio driven wheel
speed is not constant