1. SPA CONTROL ERROR MESSAGES: . continue use ofthe spa and contact a qualified
The BL-SO and BL-60 Series incorporate a service technician to correct the problem.
variety of diagnostic and protection features. S
In the event of a system error, an error mes- ~I I BL·SO
sage will be indicated by one or more blinking
LED's on the Temperature Display.
ALL LED'S BLINKING - The system water
anmJj
40 80 98 100 101 102 103 104 'F
tem~erature has exceeded :18°F (48°C),
causmg the heater to automatically shut off. BOTH RED (104 & 102) LED'S ARE ILLUMI·
When the water temperature has dropped NATED - The water temperature regulating
below 104°F (40°C), press either the £. or T sensor has malfunctioned or is not properly
touchbutton to reset the heater. If this error c?nnec.ted. If this error message is displayed,
message continues to occur, discontinue use discontinue use of spa and contact a qualified
ofthe spa and contact a qualified service tech- service technician tocorrect the problem.
nician to correct the problem. BL-5J~
~J~ BL-SO
BL-5~
~l-H BL-60
~D
~ 40 80 98 100 101 102 103 104'F
RED (104) AND ORANGE (98) LED'S ARE
40 80 98 100 101 102 103 104 of
RED (104) AND ORANGE (100) LED'S ARE
I.L~UMINATED - The water temperature high-
ILLUMINATED - The Flow Switch is not mea- limit sensor has malfunctioned or is not prop-
suring adequate water flow to permit heater erly connected. If this error message is dis-
operation. Checkhttp://www.MyPoolSpas.comPool and Spa Parts 920-925-3094 of the spa and
Wholesale
the spa for closed valves, played, discontinue the use
low :vater lev~l, obstructions, or a dirty filter contact a qualified service technician to cor-
cartridge. Ifthis error message continues, dis- rect the problem,