1. Time
EL/GL Series - Mach 3
When time hasn’t been programmed, the “ ” icon
flashes. (Time settings on EL1000 and some EL2000 systems
ML700 Quick Reference Guide are not preserved in the event of power loss; time will have to
be reprogrammed upon each power up.)
Time Warm Light Blower
F1 Setting the Time
F2
PL Once the spa has been properly connected the first time (every power
TL
up on the EL1000 and some EL2000 systems), notice the “ ” icon
Mode/Prog Cool Jets 1 Jets 2 appearing on the screen.
Time
Press then
Mode/Prog
Initial Start-up Warm
(Each press changes
Select the hour by pressing Or
When your spa is first actuated, it will go into Priming mode the time by 1 minute)
Cool
(after displaying some configuration information). Please Press to enter.
see the M-7 Installation Instruction Manual for complete Mode/Prog
Warm
instructions on Power-up and Pump Priming. (Each press changes
Select minutes by pressing Or the time by 1 minute)
The Priming mode will last for up to 4 minutes and then the Cool
spa will begin to heat and maintain the water temperature to exit the time setting procedure and enter the
in the Standard mode. You can exit Priming mode early by Press optional filter cycle programming. (Exits programming
Mode/Prog
pressing “Warm” or “Cool.” on some EL1000 and some EL2000 systems.)
Time
Press to exit programming.
2. Standby Mode
Mode/Prog
Pressing “Warm” or “Cool” then “Jets 2” will turn off all
This button is used to switch between standard, economy, spa functions temporarily. This is helpful when changing a
and sleep modes. Press “Mode/Prog” to enter mode filter. Pressing any button resets the spa. On some systems
programming, press “Cool” to cycle through to desired mode the “Jets 1” button will control the pump in Standby Mode
(LCD flashes until confirmed), then press “Mode/Prog” to (“Drain Mode”). In this case, press any other button to exit.
confirm selection.
Locking the Panel
Standard mode maintains the desired temperature. Note that
the last measured spa temperature displayed is current only Press “Time” “Jets 1” then “Warm” within 3 seconds. When
when the pump has been running for at least 1 minute. The locked, the PL “ PL ” light will light. All buttons are frozen
“ ” icon will display until the mode is changed. except the “Time” button. To unlock the panel, press “Time”
“Jets 1” then “Cool.”
Economy mode heats the spa to set temperature only during
filter cycles. The “ ” icon will display until mode is Locking the Set Temperature
changed. Pressing “Jets 1” while in Economy mode puts the Press “Warm” or “Cool” then “Time,” “Jets 1,” and “Warm”
spa in Standard-In-Economy mode, which operates the same as within 3 seconds to activate the lock. The TL “ TL ” light will
Standard Mode, then reverts to Economy Mode automatically light when the set temperature is locked.
after 1 hour. Both the “ ” and “ ” icons
display in this mode. During this time, a press of the To unlock the set temperature, press “Warm” or “Cool” then
“Mode/Prog” button will revert to Economy Mode immediately. “Time,” “Jets 1” and “Cool.”
Sleep mode heats the spa to within 20°F (11°C) of the set Additional Features
temperature only during filter cycles. The “ ” icon will Refer to your User Guide for additional details and features that
display until mode is changed. are available with your ML700 panel and EL/GL Series system.
900854
P/N 40520-80_B 06/14/2006