Pharmaceuticals, paint and coatings, adhesives, and other sectors use the potent and adaptable chemical known as methylene chloride solvent extensively. In order to fulfil the highest industry standards, Elchemy provides premium-grade methylene chloride solvent. To find out more about our wide selection of chemical products, including our premium methylene chloride solvent, get in touch with us right away.

1. MATERIAL SAFETY DATA SHEET
Di-chloro Methane
SECTION I: Identification of the Substance and the Company
1. Identification:
Product form : Substance
Substance name : Di-chloro Methane
CAS-No. : 75-09-2
Formula : CH2Cl2
Synonyms : Metheylene Chloride
2. Recommended Use and Restriction of Use:
Use of the substance/mixture : Industrial Use
Use of the substance/mixture : Chemical raw material Solvent
3. Supplier Details:
Company name: BizinBiz Technologies Pvt Ltd
Company Address: A-448, Pocket 2, Sector 8, Rohini,
New Delhi, Pin Code: 110085, India
Company Web Site: www.elchemy.com
Mobile number: +919867099519
Email Id: info@elchemy.com
SECTION II: Hazards Identification
1. Classification of substance or mixture:
Class – 6.1 U.N. No. 1593 Hazchem No. 2 Z
NFPA Rating :- Health – 2 Fire – 1 Reactivity - 0
SECTION III: Composition/Information on Ingredients
1. Substances:
Name: Methylene Chloride
Product identifier: CAS-No.: 84-66-2

2. SECTION IV: First Aid Measures
1. Description of necessary first aid measures:
a. First-aid measures general : If you feel unwell, seek medical advice.
b. First-aid measures after inhalation : Remove the victim to fresh air area,
provide oxygen if required.
c. First-aid measures after skin contact : Remove contaminated clothes from
the body and wash affected areas of the body with plenty of water.
d. First-aid measures after eye contact : Wash eyes with plenty of water for
15 minutes.
2. Indication of any immediate medical attention and special treatment needed:
Treat symptomatically
SECTION V: Fire Fighting Measures
1. Extinguishing Media:
a. Suitable Extinguishing media: Water
2. Special hazards arising from the substance or mixture:
a. Hazardous decomposition products in case of fire : Vapors are invisible
spread along the ground.
3. Advice for firefighters:
Firefighting instructions : Cool tanks/drums with water spray/remove them into
safety.
Use Protective equipment for protection against Fire.
SECTION VI: Accidental Release Measures
1. Personal precautions, protective equipment and emergency procedures:
Shut off leaks if without risk, absorb on sand or earth.
Disperse & flush. Workers involved in clean up must use protection against
skin-contact & respiratory tract.

3. 2. Reference to other sections:
No additional information available
SECTION VII: Handling and Storage
1. Precautions for safe handling:
Transferring by hand using open bucket is not recommended because spillage is
almost unavoidable. Avoid physical contact, use PPE.
2. Conditions for safe storage, including any incompatibilities:
Store in a cool dry well ventilated location, away from heat.
A separated covered storage area should be provided for drums.
Drums/ barrels should be airtight, leak proof; direct sunlight should be avoided
during transportation.
SECTION VIII: Exposure Controls
1. Control parameters:
TLV (ACGIH) 50 ppm 175 mg/m3
2. Appropriate engineering controls:
No additional information available
3. Individual protection measures, such as personal protective equipment:
PVC hand gloves, gas mask with canister, on line respirator, B.A. Set polycarbonate
goggles, face shield, gum boots PVC apron. Provision of safety shower, eye washer.
SECTION IX: Physical and Chemical Properties
General Information:
1. Appearance: Colorless
2. Physical state: Liquid
3. Odor: Ether like odor pleasant odor
4. Boiling range/point: 40.10 °C
5. Vapor pressure at: 420mm hg at 25 °C

4. 6. Vapor density (air = 1): 2.93, at 20 °C
7. Solubility in water: 2%
8. Specific Gravity water: 1.335 at 20°C
SECTION X: Stability and Reactivity
1. Reactivity: Reacts violently with Li, Na, K
2. Chemical stability: Stable (stabilizer is added before – dispatch)
3. Incompatible materials: Strong oxidizers, caustics chemically active metals with
other material such as Al, Mg Powder, Na K
4. Hazardous decomposition products: When heated to decomposition, emits toxic
fumes.
SECTION XI: Toxicological Information
1. LD50 oral rat: 2136 mg/kg body weight (Equivalent or similar to OECD 401, Rat,
Male / female, Experimental value, Oral, 14 day(s))
2. Symptoms/effects after skin contact : Irritation of eyes & respiratory tract,
headache,
vomiting – unconsciousness.
SECTION XII: Ecological Information
No data found.
SECTION XIII: Disposal Considerations
Dispose in accordance with all applicable regulations. Subject to disposal
regulation: US EPA 40 CFR 262, Hazardous Waste number(s) - U080
SECTION XIV: Transport Information
Regulated shipping identification name:- Hazchem No. 2 Z Code/Label
Methylene Dichloride poison, class 6.1
Hazardous Waste I.D. No. 6
Packing group I / II
SECTION XV: Regulatory Information
No information available.
SECTION XVI: Other Information

5. No additional information available