Mtd bar clamp instruction manual

1. MTD BAR CLAMP
INSTRUCTION MANUAL

2. 2
November 2017, Revision 0‐‐Draft
Document Number 3000112
M.T. Deason Company, Inc.
PO Box 101807
Birmingham, AL 35210
Phone: 205‐956‐2266
Fax: 205‐956‐1911
www.mtdeason.com

3. 3
Table of Contents
Section I: Introduction ............................................................................................................................................ 4
Description .......................................................................................................................................................... 4
Safety ................................................................................................................................................................... 4
Protective Clothing .............................................................................................................................................. 4
Warnings ............................................................................................................................................................. 4
MTD BAR CLAMP ................................................................................................................................................. 4
Section II: Installation and Use ............................................................................................................................... 5
Description .......................................................................................................................................................... 5
Procedure ............................................................................................................................................................ 5

4. 4
Section I: Introduction
Description
This manual is designed to provide operating instructions for the MTD BAR CLAMP systems for 2”‐ 4” IPS and
6”‐8” IPS pipe.
Safety
WARNING: Read this manual thoroughly before operating the MTD BAR CLAMP system. Under no
circumstances should the factory recommended specifications be exceeded.
If the operator or other personnel have questions regarding the operation of this system, please contact M.T.
Deason Inc. Always refer to and follow your company’s safety procedures.
Protective Clothing
Gloves, flame retardant shirt, safety glasses, safety shoes, and hard hat are recommended. Do not wear
jewelry, loose clothing or other items that could get caught in moving parts.
Warnings
WARNINGS in this manual indicate a potentially hazardous situation which, if not avoided, could result in
death or serious injury, as well as damage to equipment. They may also be used to alert against unsafe
procedures.
MTD BAR CLAMP
The MTD BAR CLAMP system is a sturdy, simple, reliable device for clamping couplings and reducers.
WARNING: Do not attempt any clamping operation without following the procedures outlined in this manual.
Any departure from prescribed procedures could result in severe injury to personnel and/or damage to
equipment/property.
WARNING: Do not alter this equipment or any of its components. Any alteration of this equipment or use of
any of part not approved by MTD could cause the machine to malfunction, resulting in damage to the
equipment and/or severe injury to personnel.

5. 5
Section II: Installation and Use
Description
This section provides the operator with factory recommended operations for safe and effective use of the
MTD BAR CLAMP system. The examples shown are of the 2”‐4” system whose operation is the same as the
6”‐8”.
Procedure
Loosen both knobs to open clamp. Knobs are designed with a hex head which accepts a crescent or
socket wrench.
If needed, place appropriate size liner into clamp. Tighten holding pin into hole in liner, securing liner
to clamp. If clamping a reducer, place liner in one side only.

6. 6
Place an assembled joint in clamp as shown below:
Close and tighten knobs to fasten pipe in place.
Part Number Description
TRI1754 4”IPS Bar Clamp
TRI17542 2”IPS Liner Kit for Bar Clamp
TRI17543 3”IPS Liner Kit for Bar Clamp
TRI1758 8”IPS Bar Clamp
TRI17586 6”IPS Liner Kit for Bar Clamp

7. 7