This document describes a free energy water pump system that operates without electricity or fuel. It works by using an air compressor to pressurize air that pushes water through pipes from an inlet to an outlet valve. The system includes components like an air compressor, elbow joints, pipes, tees, valves, and a reducer. It was tested and found to effectively pump water without electricity while reducing costs and being environmentally friendly. However, it requires different materials and has a higher initial cost than traditional pumps.

1. INTRODUCTION
 This is free energy water pump system
 it is operated by without electricity and without fuel
 In this process we can save electricity and we can supply of water without electricity .
 Upcoming generation water and electricity are most important
 Less amount of water are supply provided to village areas.
 Village peoples are strugling for electricity by this process we can solved electricity
problem
 In this system we can easily pump the water

2. WORKING PRINCIPLE DIAGRAM
Outlet
Air Compressor
Reducer
Valve
Inlet
Footvalve
Elbow
Tee

3. Name of the
components
Number
of unit
Mm/Lit/Length
Air Comressor 1 75 mm
Elbow 10 25 Mm
Joinder 2 25 Mm
Pipe Nipple 1 12.5 Mm/25 Mm
Valve 2 25Mm
Pvc pipe 1 2 Mts
Tee 4 25 Mm
Reduser 3 75 Mm/62.5 Mm/25Mm
Solvent 2 200 Mm
Teflon Tape 1 1 Mts
Air pump 1 -
Cap 1 75 Mm

4. METHODOLOGY
FREE ENERGY WATER PUMP
AIR COMPRESSION METHOD
APPLICATION
PERFORMAS
CONNECTION
TESTING
OBSERVATION
CONLUSION
END

5. WORKING
 The saved water tank inlet is connected through the foot valve(25mm)
by the poly venyl chloride (pvc)(25mm) the other is connected
through the tee joint 25mm the other end is connected to outlet valve
by elbow (25mm)
 The water flows through the foot valve through inlet valve by the
pressure of air compressor cylinder
 Air compressor the maintain air and water pressure of whole system
 To improve the efficiency of pump by using different material and
their work system with minimum input gives maximum output
 When the out let valve was opened the free energy water pump is
generated high compression is produced

6. WORK DONE TILL DATE
 Title substantiated.
 Survey of existing models.
 Survey of materials.

7. ADVANTAGE OF THIS PROJECT
 It has low Maintenance cost
 It has low operating cost compare to
traditional water pump system
 Free electricity water pump system
environmentally friendly
 It avoid use of electricity

8. DIS-ADVANTAGES OF THIS PROJECT
 It has higher initial cost
 Due to their design different types of material
are required
 During pumping hours the inflow of water
through leaks may cause water contamination
 Routing inspection are required due to water
pressure and air pressure

9. RESULT
 testing of our project we got positive output.
 We have been able to reduce the man power.
 No requirement of electricity and their by reducing overall cost
during implementation.
 pump are easy to operate

10. CONCLUSION
 our project should be the best option for in load sheding
problems
 also not so much hard work to lift the water.
 it is best option for farmer which are economically backward
 It is very simple in construction and also it is very easy to handle
that device.

11. Thank you!