This document provides wiring instructions for installing a Python 323 alarm system on a 2004 Honda CR-V. It includes wiring diagrams for the main harness, door lock harness, auxiliary harness, and starter kill harness. The main harness diagram lists 12 wires for functions like constant power, ground, trunk release, door triggers, siren output, and more. The door lock harness diagram lists 8 wires for locking and unlocking the doors. The auxiliary harness provides wires for additional outputs and an ignition input. The starter kill harness requires cutting one wire and connecting it as directed to install a starter kill feature.

1. PYTHON 323 ON 2004 HONDA CR-V
H-1:MAIN HARNESS
ALARM WIRE COLOR CAR WIRE COLOR LOCATION
1 (-) 200mA TRUNK RELEASE OUTPUT RED/WHITE BLACK / YELLOW (-)
2 (+) 12VDC CONSTANT INPUT RED WHITE Ignition Switch Harness
3 (+) SIREN OUTPUT BROWN Siren( +) wire
4 PARKING LIGHT ISOLATION WIRE-PIN 87a OF ONBOARD RELAY WHITE/BROWN X
5 (-)CHASSIS GROUND BLACK Ground to Chassis
6 (+)DOOR TRIGGER INPUT VIOLET X
7 (-)TRUNK PIN/INSTANT TRIGGER INPUT (NC or NO) BLUE GREEN / WHITE (-)
8 (-)DOOR TRIGGER INPUT (NC or NO) GREEN 1**
9 FLEX RELAY OUTPUT BLACK/WHITE X
10 (-) 200mA AUX1 OUTPUT WHITE/BLUE X
11 PARKING LIGHT OUTPUT WHITE RED/YELLOW (+) under dash at FUSE BOX
12 (-) 500mA GROUND WHEN ARMED OUTPUT ORANGE GROUND(-)
1**DRIVER:GREEN(-)PASS+REAR: GREEN/RED(-)DIODE Isolate
H-2:DOOR LOCK HARNESS
1 UNLOCK #87 NORMALLY OPEN (INPUT) VIOLET GROUND (-)
2 UNLOCK #30 COMMON (OUTPUT) BLUE/BLACK WHITE/GREEN DRIVER KICK PANEL
3 UNLOCK #87a NORMALLY CLOSED BROWN/BLACK X
4 LOCK #87 NORMALLY OPEN (INPUT) VIOLET/BLACK GROUND (-)
5 LOCK #30 COMMON (OUTPUT) GREEN/BLACK WHITE/BLUE
6 LOCK #87a NORMALLY CLOSED WHITE/BLACK X
7 FLEX RELAY #87 NORMALLY OPEN WHITE/VIOLET X
8 FLEX RELAY #87a NORMALLY CLOSED WHITE/BROWN X
H-3: AUXILARY HARNESS
1 (-)200mA AUX 4 OUTPUT ORANGE/BLACK X
2 (-)200mA AUX 3 OUTPUT WHITE/BLACK X
3 (-)200mA AUX 2 OUTPUT WILET/BLACK X
4 (-)200mA FACTORY ALARM DISARM OUTPUT LIGHT GREEN/BLACK X
5 (+) IGNITION INPUT YELLOW BLACK/YELLOW
6 (-)200mA HORN HONK OUTPUT BROWN ORANGE
7 N/O or N/C (-) HOOD PIN SWITCH GREY X
STARTER KILL HARNESS
BLACK / WHITE wire, located under dash at FUSE / RELAY BOX Starter
Wire Must Be Accessed After Fuse Block To Prevent Check Engine Light. Cut BLACK/WHITE wire & connect as directed.
1 STARTER-COMMON (KEY SIDE) GREEN/WHITE KEY SIDE BLACK/WHITE
2 STARTER-NORMALLY OPEN(MOTOR SIDE) GREEN MOTOR SIDE BLACK/WHITE
3 STARTER-NORMALLY CLOSED(MOTOR SIDE) GREEN/BLACK X