2. Is the power lamp on?
Yes No
Note: not all sealers have a power lamp.
Return to start
Sealer not sealing
3. Is sealing lamp on when jaw or handle is pressed down?
Yes No
Return to start
Sealer not sealing
4. Possible cause(s):
Possible solution(s):
1. Replace element wire
2. Tighten spring hook connections
3. Clean the terminals of elements.
1. Heating element wire is broken.
2. Loose mounting spring.
Return to start
Sealer not sealing
5. Possible cause(s):
1. Plug back into electrical outlet
2. Replace plug
3. Repair cord
4. Replace transformer
1. Disconnected plug
2. Disconnected power cord
3. Bad transformer
Possible solution(s):
Return to start
Sealer not sealing
6. Possible cause(s):
1. Adjust micro-switch lever
2. Reposition micro-switch
3. Replace micro-switch
1. Micro-switch de-activated
2. Defective microswitch
Possible solution(s):
Return to start
Sealer not sealing
7. Return to start
Possible cause(s):
1. Replace timer and / or relay
2. Replace relay and / or timer
3. Decrease amount of heating time
1. Timer malfunction
2. Extended heating time by user
Possible solution(s):
Burnt Teflon cloth
8. Possible cause:
Return to start
1. Replace Teflon strip
2. Decrease timer setting
Worn Teflon strip
Possible solution(s):
Broken heating wire
9. Possible cause(s):
Return to start
1. Lower timer setting
2. Increase cooling time (Manual Mode -
continue to press upper lever for 1 - 2
seconds after the light goes off)
1. Heating timer set too high.
2. Cooling setting too short.
Possible solution(s):
Wrinkled seal
10. Possible cause(s):
Return to start
1. Replace Teflon strip
2. Replace silicone rubber
1. Worn Teflon cover.
2. Worn silicone rubber.
Possible solution(s):
Imperfect seal
11. Possible cause:
Return to start
Decrease timer setting
Sealing time is too long
Possible solution(s):
Broken seal
12. Possible cause:
Return to start
Increase timer setting
Sealing time is too short
Possible solution:
Seal is not complete
13. Possible cause:
Return to start
Clean the Teflon cover and silicone rubber
Dirty teflon cloth and dirty sealing bar
Possible solution:
Bag is sticking to sealer