The document discusses fractional CO2 laser technology and its applications. It can be used to treat various skin conditions like wrinkles, scars, and pigmentation by vaporizing thin layers of skin with minimal heat damage. The laser works by scanning the skin in a pattern with micro thermal zones to stimulate collagen production for skin tightening and renewal. It also describes using different handpieces and treatment modes for skin resurfacing, scar removal, and vaginal rejuvenation procedures.

1. Fractional Co2 Laser
Carbon Dioxide 10600nm

2. Introduction
 Co2 has been used for years to treat different skin
issues, including wrinkles, scars, warts, enlarged oil
glands on the nose, and other conditions.
 The newest version of CO2 laser resurfacing
(fractionated CO2) uses very short pulsed light
energy (known as ultra pulse) or continuous light
beams that are delivered in a scanning pattern to
remove thin layers of skin with minimal heat damage.

3. Applications
 Fractional Co2 laser is designed to cut, burn, vaporize, and solidify tissue
for different clinic surgery purposes with different headpieces.
 1. Skin renewing and resurfacing
 2. Wrinkle removal, skin tightening
 3. Age spots and acne scar removal
 4. Smooth burnt scars and surgical scars
 5. Remove intractable chloasma and pigmentation
 6. Sun damage recovery
 7. Cut skin neoplasm, abnormal growth
 8. Virginal tightening

4. How to work for scars wrinkle removal
 The Fractional CO2 Laser vaporize lines, wrinkles, scars, dark spots and
other irregularities, layer by layer. This process also stimulates the formation
over time of new, underlying collagen to provide better elasticity and support
for the skin.
1. Skin with problems before treatment 2. Fractional laser works on the skin
3.Thousands of micro thermal zones 4. More collagen is produce after
treatment are produced activate skin resurfacing
 The Laser beam is absorbed well in water which causes destruction by rapidly
heating and vaporization of the tissue.

5. How to Works for Vaginal Tightening
Throughout the aging process our facial skin looses its vitality, wrinkles
appear, and elasticity is reduced due to Collagen fibers fatigue. This is why
so many women around the world, take cosmetic steps such as facials,
innovative creams, and aesthetic procedures to ensure their face looks as
young as possible.
Same process occurs in the vaginal tissue area where collage fibers loose
their elasticity while we age, and give birth.
Due to structural changes in the vagina and urethra area and the loss of
Collagen fibers' firmness, this phenomenon can cause reduction in sexual
fulfillment in addition to stress urinary incontinence at different severity
levels.

6. Treatment hand piece
 Different hand pieces (one scanner, two cutter,3 Virginal handpiece)
typically used for cutting or vaporization or virginal tightening.
The spot size for scanner can be adjustable.

7. Operation Modes
 Scan Mode Impulse mode
 The CO2 laser can be used in the continuous mode of operation for making
relatively bloodless incisions and reducing adjacent tissue damage and post-
operative swelling. In Pulsed mode, the laser produces a train of relatively
high power short duration pulses. By which, a smaller residual zone of thermal
Damage will occur than with continuous mode. Ultra pulsed mode, produces
very short pulses (< 1ms) at high power that can remove thin layers of skin in a
single pass with little thermal damage compared to pulsed mode.

8. Specifications
 Laser Type Fractional CO2 Laser
 Wavelength 10,600nm
 Output Power 30W
 Spot Size 0.1mm
 Lens Focal Distance 100mm&75mm&50mm
 Scan mode Scanning area 0.1*0.1mm ----20*20mm
Scanner Mode Rectangle, Square, Circle, Ellipse, Triangle
Scanning Density 0.1-9cm2/S
Scanning Depth <2mm
Scanning power 24mj-1000j
 Pulse Mode Pulse mode power 1-30W
Pulse Interval time 0-999ms
Pulse Duration 90-1000μm
Pulse Frequency 0-999Hz
 Beam Delivery 7 Joint Spring-Balanced Arm
 Cooling System Air Cooling system
 Control Panel Wide LED Panel Touch Screen
 Power Supply AC 230V/50Hz; AC110V /60Hz

9. Scanning mode
Scan mode: Ellipse, Rectangular, Triangular, Line,
Square, hexagon, round
Repeat Delay: 0.1s---- 5.0s.
Micro Pulse Energy: 5mJ---50mJ.
Treatment Level: 0.30%-----25.0%.
Passes: 1-----10 times.
Estimated Power: 24mJ--1000J.
Ellipes estimated power 31mJ----1000J
Rectangular estimated power: 24mJ----981J
Treatment area: 0.1*0.1mm, ----- 15*15mm.(F=50mm)
Handpiece Velocity: 0.1-----9cm2/s
Scanning Depth: ≤2.0mm

10. Scanning

11. Treatment

12. Vaginal Treatment
Working mode: 360 degree revolution
Treatment depth: 100mm
Treatment head diameter 30mm
Max Scanning diameter: 9*9mm2
Spot Size Diameter: 0.2-1.0mm
Focus length: 150mm
Suggestion parameter setting: 30-40mj/pin

13. Vaginal Tightening

14. Advantages of RF tube
Fractional Co2 laser
 Applicable to all skin types (Skin Types I-VI)
 Produce high, stabilized out-put energy and high quality beam
 Uniform spot tiny holes (0.1*0.1mm ----20*20mm)
 Multiple Treatment Modes Optional
 1. Scan Mode
CW -----Continuous Wave mode
 2. Modes Impulse Mode Pulse
Ultra pulse
 Patient-personalized settings
 7 Joint Spring-Balanced Arm