Meta Maya Construction Pty Ltd Induction Quiz

1. MMC Induction Questionnaire
Click to continue

2. IMPORTANT INFORMATION
Click to continue
PLEASE READ BEFORE COMMENCING THE QUIZ
This quiz will ONLY work by clicking through and answering each question.
You will not advance through the quiz If you do not answer each question.
Scrolling will cause the quiz to shut down, if this happens simply open
The quiz and start again. Good luck.

3. This quiz is made up of 14 multiple
choice questions. The quiz should take you
Approximately 10 minutes
Click to continue

4. Questions 1
Who do you have a duty of care to?
A. Yourself
B. Others
C. Both A and B

5. Questions 2
To whom do you report hazards, incidents, injuries or
near misses to?
A. Worksafe
B. MMC Site Management
C. General Manager
D. None of the Above

6. Questions 3
If working near an unprotected edge where there is a fall of 2
metres or more you must:
A. Have a fall protection system in place
B. Be trained in working at heights
C. Have the work at heights activities included in your SWMS
D. All of the above

7. Questions 4
If you have to enter areas where mobile plant are working
ensure that you:
A. Make eye contact with plant operator and make sure they
have stopped before you approach
B. Are wearing a helmet
C. Have a permit
D. Have checked the ground conditions for any uneven
surfaces

8. Questions 5
What are the requirements when using electrical equipment?
A. Must be tagged
B. Each item must be checked for condition each day
C. Extension leads must be protected from damage and
conductive liquids
D. All of the Above

9. Questions 6
What should you do if you hear the evacuation signal?
A. Immediately proceed to the Muster point
B. Make sure you outrun at least one person
C. Pack up all of your equipment as you may not know if
you will be returning to site
D. Notify your next of kin

10. Questions 7
When conducting manual tasks you should always:
A. Assess the weight and if safe use correct lifting
techniques
B. Make sure everyone can see just how much you can lift
C. Use mechanical assistance such as trolley or forklift
D. Use team lifting techniques. A, C and D

11. Questions 8
It is ok to enter an exclusion zone only if you obtain
permission from the person controlling the exclusion zone
A. True
B. False

12. Questions 9
If you are in a piece of machinery that comes into contact
with underground or overhead power, and remains in
contact you should:
A. Jump straight out of the machine
B. Stand on top of the machine
C. Remain in the machine if it is safe to do so until the
power is disconnected
D. Step off the machine slowly

13. Questions 10
What is an essential control measure that you should have in
place when you are working with large items, such as
structural steel or concrete panels, that have the potential to
fall on people?
A. Adequate PPE
B. An exclusion zone with physical barriers and signage
C. Work at heights training
D. First Aid Supplies

14. Questions 11
You should never work elevated over a handrail
A. True
B. False

15. Questions 12
It is fine to use electrical tools without checking them for
damage prior to use
A. True
B. False

16. Questions 13
Leads should not be joined in a series such that the total
length exceeds 30 metres.
A. True
B. False

17. Questions 14
Where there is a risk of falling objects, no exclusion zone
needs to be set up
A. True
B. False