Ecway Technologies provides IEEE projects and software development services for power electronics. It has offices in multiple cities in India. The document then lists over 100 project titles from 2013 in areas like boost converters, buck converters, inverters, motor drives, renewable energy, resonant converters, and more. Contact information is provided at the end.
1. ECWAY TECHNOLOGIES
IEEE PROJECTS & SOFTWARE DEVELOPMENTS
OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE
BANGALORE / HYDRABAD
CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111
VISIT: www.ecwayprojects.com Mail to: ecwaytechnologies@gmail.com
2013IEEE POWER ELECTRONICS PROJECT TITLES
BOOST CONVERTER
1
Analysis, design, and performance evaluations of an edge-resonant switched capacitor cellassisted soft-switching PWM boost dc–dc converter and its interleaved topology
2
DCM analysis and inductance design method of interleaved boost converters
3
Interleaved boost converter with ripple cancellation network
4
Interleaved high step-up ZVT converter with built-in transformer voltage doubler cell for
distributed PV generation system
5
Reduced-order model and control approach for the boost converter with a voltage multiplier
cell
BOOST RECTIFIER
1
Adaptive dead-times compensation for grid-connected PWM inverters of single stage PV
systems
2
Improved voltage-vector sequences on dead-beat predictive direct power control of
reversible three-phase grid-connected voltage-source converters
3
Nonlinear behaviors and instability in a three-phase boost rectifier connected to a non-ideal
power grid with an interacting load
4
The Taipei rectifier—a new three-phase two-switch ZVS PFC DCM boost rectifier
BUCK CONVERTER
1
A dc–dc converter based on the three-state switching cell for high current and voltage stepdown applications
2
A high step-down transformerless single-stage single-switch ACDC converter
2. 3
Interleaved boundary conduction mode (BCM) buck power factor correction (PFC) converter
4
Light-loads efficiency improvement in buck-derived single-stage single-switch PFC converters
5
Series asymmetrical half-bridge converters with voltage auto balance for high input-voltage
applications
DC-DC CONVERTER
1
Adaptive voltage control of the DCDC boost stage in PV converters with small input capacitor
2
High-efficiency single-input multiple-output dc–dc converter
3
Soft-switching dc-dc converter with a full ZVS range and reduced output filter for highvoltage applications
4
Unterminated small-signal behavioral model of dc–dc converters
INDUCTION HEATING
1
Mutual impedance of small ring-type coils for multiwinding induction heating appliances
INVERTER
1
A single-phase grid-connected fuel cell system based on a boost-inverter
2
Mitigation of lower order harmonics in a grid-connected single-phase PVinverter
LED DRIVE
1
A new control method of interleaved single-stage fly back AC–DC converter for outdoor led
lighting systems
2
An adaptive output current estimation circuit for a primary-side controlled led driver
3
Electric equivalent model for induction electrode-less fluorescent lamps
4
High-efficiency asymmetrical half-bridge converter without electrolytic capacitor for lowoutput-voltage ac–dc led drivers
5
Light-to-light PV-fed led lighting systems
MOTOR DRIVES
1
A current controller design for current source inverter-fed ac machine drive system
2
Improved sensor-less operation of a CSI-based induction motor drive long feeder case
3
Common-mode voltage reduction methods for current-source converters in medium-voltage
drives
4
Precise accelerated torque control for small inductance brushless dc motor
5
Problems incurred in a vector-controlled single-phase induction motor, and a proposal for a
3. vector-controlled two-phase induction motor as a replacement
MULTILEVEL INVERTER
1
Asymmetric control of dc-link voltages for separate MPPT’s in three-level inverters
2
Multilevel dc-link inverter and control algorithm to overcome the PV partial shading
POWER FACTOR CORRECTION
1
Digital plug-in repetitive controller for single-phase bridgeless PFC converters
2
High power factor ac–dc led driver with film capacitors
3
Input differential-mode EMI of CRM boost PFC converter
4
5
Perturbation on-time (pot) technique in power factor correction (PFC) controller for low
total harmonic distortion and high power factor
Triple loop modulation (TLM) for high reliability and efficiency in a power factor correction
(PFC) system
RENEWABLE ENERGY
1
2
3
4
5
6
7
A high step-up converter with a voltage multiplier module for a photovoltaic system
A new dc anti-islanding technique of electrolytic capacitor-less photovoltaic interface in dc
distribution systems
A single-phase grid-connected fuel cell system based on a boost-inverter
An optimal control method for photovoltaic grid-tied-interleaved fly-back micro-inverters
to achieve high efficiency in wide load range
Analysis, design, and experimental results of a novel soft-switching snubber-less currentfed half-bridge front-end converter-based PV inverter
Application and stability analysis of a novel digital active EMI filter used in a grid-tied PV
micro-inverter module
Design and implementation of energy management system with fuzzy control for dc microgrid systems
8
Design optimization of transformer-less grid-connected PV inverters including reliability
9
Design, analysis, and implementation of solar power optimizer for dc distribution system
4. Development and operational control of two-string maximum power point trackers in dc
10
distribution systems
Dual transformer-less single-stage current source inverter with energy management control
11
strategy
Grid interfacing of multi-megawatt photovoltaic inverters
12
Integration and operation of a single-phase bidirectional inverter with two buck/boost
13
MPPT’s for dc-distribution applications
14
Modeling and simulation of all-electric ships with low-voltage dc hybrid power systems
15
Novel energy conversion system based on a multimode single-leg power converter
16
Origin of cross-coupling effects in distributed dc–dc converters in photovoltaic applications
17
Reconfigurable solar converter a single-stage power conversion pv-battery system
Synchronous-reference-frame-based control of switched boost inverter for standalone dc
18
Nano-grid applications
Synthesizable integrated circuit and system design for solar chargers
19
RESONANT CONVERTER
1
Analysis of a fifth-order resonant converter for high-voltage dc power supplies
2
Design methodology for a very high frequency resonant boost converter
3
Hybrid-frequency modulation for PWM-integrated resonant converters
SEPIC CONVERTER
1
Bridgeless SEPIC converter with a ripple-free input current
STATCOM
1
Adaptive theory-based improved linear sinusoidal tracer control algorithm for dstatcom
UNINTERRUPTIBLE POWER SUPPLY (UPS)
1
A high-performance SPWM controller for three-phase ups systems operating under
5. highly nonlinear loads
2
Battery / super capacitors combination in uninterruptible power supply (ups)
WIND ENERGY
1
2
3
4
Control of improved full-bridge three-level DCDC converter for wind turbines in a dc
grid
Dc-voltage fluctuation elimination through a dc-capacitor current control for DFIG
converters under unbalanced grid voltage conditions
Analysis and comparison of medium voltage high power DCDC converters for offshore
wind energy systems
Enhanced control of a DFIG-based wind-power generation system with series grid-side
converter under unbalanced grid voltage conditions
Z SOURCE INVERTER
1
Cascaded multicell trans-z-source inverters
2
Generalized multicell switched-inductor and switched-capacitor z-source inverters
3
4
Improved trans-z-source inverter with continuous input current and boost inversion
capability
Space-vector-modulated three-level inverters with a single z-source network
BATTERY CHARGER
1
Synthesizable integrated circuit and system design for solar chargers
2
Zero no-load power ACDC adapter for electronic equipment with embed battery