Vibrating Feeder Supplier,Industrial Feeding Machine for Mining Industry

1. http://www.beneficiationmachine.net/
Vibrating Feeder several common errors
1 Buy a Vibrating Feeder should be some sort of test before Feeders
Test is an effective way to assess the overall level of features and the seller of the Vibrating
Feeder . But not just any test can be carried out . To test the Vibrating Feeder must be based on
your specific goals based write a written plan , and should be carried out under conditions as
close to the actual production conditions . Trials should use the same materials and production ,
and transportation of materials in the same way . For example , the powder with a dilute phase
pneumatic transportation powder delivered by other methods having different flowability , bulk
density may be higher than 33% .
Feeders should be evaluated in the multiple feeding performance , might beat the body surface
Vibrating Feeder operation to detect the operation of the Vibrating Feeder when unplanned
interference.
Most Vibrating Feederfeeding problems and multiple feed , and therefore the test should
simulate multiple feed feeding system .Vibrating Feeder Manufacturers should be aware of the
experience of the device settings , such as: Feed several times per hour , or how much material at
the beginning of the feed hopper again . In addition , it should assess the need for multi- interval
time to clean the Vibrating Feeder . Requires certain pigments and additives and a hopper
Vibrating Feeder with a special plastic or highly polished steel to facilitate cleaning.
2 above the Vibrating Feeder can be mounted anywhere in the extruder
When installing the Vibrating Feeder to observe equipment operation environment. Vibration
must be minimized , into the hopper and Vibrating Feeder vent line ( to prevent system blocking )
must not touch the measurement scales .
If there are a lot of people around the equipment at the event , it may be time Vibrating Feeder
car crash or falling objects on it, this time must understand the measurement scales measuring
durability and replacement of damaged scales required fees. Some scales are expensive and
difficult to buy.
3 . Decided Vibrating Feeder control system engineers, rather than operatives
Instrumentation and control engineers and process engineers responsible for selecting and
planning Vibrating Feeder control system, and the operator must be involved in the detailed
design of the control system. Engineers often want to control the system with all the alarm bells .
Theoretically speaking the idea is good, but the actual logical operators prefer to display on the
control panel clear. So should carefully consider the level of protection of the display ( usually
there are three levels of protection : operatives, equipment maintenance and engineering ) ,
otherwise your feeding system may take a long time to drive , because it 's too difficult to debug

2. http://www.beneficiationmachine.net/
control system .
4.Vibrating Feeder weightlessness compensation is too complicated, is not accurate enough
Updated measurement scale electronic components and make better logical calculus with screw
Vibrating Feeder belt Vibrating Feeder or feeders as accurate . For the vulnerable , fragile
products for ( such as chopped glass fiber ) , vibrating hopper , sometimes coupled with a
low-speed rotation of the screw, would be the right choice. When 22 tests proved vibrating
Vibrating Feeder to 330 ~ 760lb / h speed Gache broken glass filled with glass fiber for the
production of 35% nylon 66 , the accuracy rate of 0.015% .
Determine whether the normal operation of the Vibrating Feeder easiest way is to observe the
driving instructions. Driving directions displayed screw Vibrating Feeder motor speed or belt
Vibrating Feeder belt speed. If the fluctuation -driven instruction is ± 5%, while Vibrating Feeder
feed rate display ± 1%, then the feed rate of the logical calculus will hide the short-term
fluctuations .