1. PET BOTTLE PURSE E
by ZITTA SCHNITT OPEN FRE
SOURCE
Instruction Tutorial v 1.2 DESIGN
PDF download only from www.zittaschnitt.com !
Copyright © 2009-2010 Zitta Schnitt, All rights reserved. For non-commercial use only.
HOW TO BUILT A PET BOTTLE PURSE ...STEP-BY-STEP
Following this introduction you can build a „PET Bottle Purse“ out of two bottoms of PET bottles and a zipper. You can
use the box as a coin purse or as storage-box.
Do not scale document when printing!
# Tools: # Materials:
1 knife 2 PET bottles 0,5 l
1 small pair of scissors 1 Zipper - 20 cm
1 thin needle 1 adhesive tape
1 thick sharp needle 1 Nylon thread
zipp-fabric
start
1. First, cut off the bottoms of the bottles zipp-start
approximate, afterwards cut off the excess
material, along the burr with the small
sissor.
*
2. Cut out the auxiliary construction and
stick it to the edge of the cut-out bottom
with adhesive tape.
3. Use the thick needle to pierce the
bottom, where the auxiliary construction
marks the stitching-holes with dots. For
holding the needle us a combination pliers.
4. Remove auxiliary construction.
Zipp-end
5. Before sewing, open the zipper. Start to stich
with the small needle, 3cm after the zipp-start *
and sew the zipper all around the first bottom. zipp-fabric
end
6. Attention! Don‘t complete sewing the whole circumference,
before finishing, overlap the zipp-fabric end, thats how you
build a nice PET :)
Auxiliary Construction
Become a fan of PET BOTTLE PURSE on facebook!
Copyright © 2009-2010 Zitta Schnitt, All rights reserved. // www.zittaschnitt.com // office@zittaschnitt.com // 00436506592404 // Springergasse 27 | 13, 1020 Vienna, Austria