This document describes the process of placing an inlay dental restoration using a Griptab Inlay Case. First, a Wave-Wedge is placed in position. Then, an inlay is placed using a Triodent Griptab handling aid. After cementation, clean-up is performed. The Wave-Wedge is then removed using Triodent Pin-Tweezers, leaving a clean distal area where the wedge was and excess composite on the mesial area without a wedge.

1. Griptab Inlay Case By Dr Jan Hajtó, Dr. med. dent

2. 1 Wave-Wedge in position.

3. 2 Inlay being placed using a TriodentGriptab handling aid.

4. 3 Clean-up after cementation.

5. 4 The Wave-Wedge is removed using Triodent Pin-Tweezers.

6. 5 Post-op showing the clean distal area, where the wedge was placed, and the mesial area with excess composite, where there was no wedge.