With Fall Protection remaining the top OSHA citation in 2017, we are looking to partner with building owners to make their facilities safer. Whether it is an employee or a contractor, the building owner is responsible for providing these basic safety requirements.

1. Page 1
Why is Fall Protection Important?
Fall Protection remains the #1 most frequently cited standards by OSHA*. There were
6,072 fall related violations cited in 2017. Many building owners and Managers do not
realize that it is your responsibility to have the correct safety precautions in place when
employees or contractors are working on the roof. It does not apply exclusively to roof
construction or repairs. If a roof top unit (RTU), such as an air handler, is being serviced,
the same safety systems must be in place. Failing to provide a safe environment can
lead to dangerous working conditions, injuries and fines.
What is Considered Fall Protection?
• Collective fall protection – Roof edge, skylight and roof hatch guard/ handrails.
• Personal fall protection – Horizontal lifeline, portable dead weight anchor system.
• Safety Railings
• Dedicated Safety Watch
*OSHA Construction Standard 1926.501 - Fall Protection as of 9/26/17.
Fall Protection
Safety is our Highest Priority, and it should be Yours!

2. Fall Protection
Page 2
Important Info to Know
When is fall protection required?
Anytime the next lowest level is more than 6 feet,
fall protection is required. Also, if a RTU is within 6
feet of the edge (without a standard parapet
wall) a protective railing is required
Where are some commonly missed
potential fall hazards?
Anyone on walking/working surfaces shall be
protected from falling through holes (including
skylights and roof hatches) more than 6 feet
above lower levels, by personal fall arrest
systems, covers, or guardrail systems erected
around such holes.
What if I need to move or install units
on the roof?
Mechanical equipment on roofs shall be used
only in areas where employees are protected by
a warning line system, guardrail system, or
personal fall arrest system.
Roof Parapet or Safety Railing?
Parapet walls must be 42” in order to pass as a
safety barrier. Railings must be 42” +/- 3” with
vertical posts spaced a maximum of 8’.

3. Fall Protection
Page 3
What do you need to do to be prepared?
These steps will help you avoid costly fines, prevent injuries and have the peace of mind
of a safe building.
Kee Safety
Tremco recommends and installs high quality, portable and non-roof penetrating
equipment made by Kee Safety. Browse their recommendations and products here:
www.KeeSafety.com/compliance/general
American National Standards Institute (ANSI)
This is a collection of standards that can be used as a reference for most common
safety guidelines. ANSI is not affiliated with OSHA and its’ standards are not
interchangeable with OSHA’s. Visit www.ansi.org for more information.
Source
https://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=STANDARDS&p_id=10757
Logan Robrock, Roofing Advisor – Tremco, Inc. an RPM Company
Step 1
Allow us to
preform a safety
audit.
We will highlight
dangerous areas
and recommend
proper safety
equipment.
Step 2
Install safety
equipment.
Have the installed
equipment
inspected and
documented.
Step 3
Create a safety
action plan.
Protoclas for
potential acidents
are required by
OSHA.