wwww.fibercasa.com

1. How to use a optical Power Meter
Preparation of the end face of the optical power meter including stripping, cleaning and cutting
these links.
Fiber optical tools. There are two fiber cleaver, the former operation is simple, reliable, with
increasing level of the operator, the cutting efficiency and the quality can be significantly
improved, and the bare fiber requires a shorter, but the cutter on the environmental temperature
higher. The latter cut high quality, suitable for operation in cold conditions in the wild, but the
operation is more complex, working speed constant, requiring a longer bare fiber; see stripping
power meter is not all, if there should be heavy residual peel. Very little, if any, is not easy to strip
the coating layer, the amount of available cotton balls dipped alcohol to wipe.
Stripping layer coated optical power meter to master level, stable, fast fiber stripping words law.
"Flat", that is to hold the fiber level. Left thumb and index finger pinch PM, make it into a
horizontal state, the exposed length of 6cm for it, more than the fiber between the ring finger, little
finger naturally bent to increase efforts to prevent slipping. "Stability", ie stripping pliers to hold
firm in fiber. "Fast", ie faster fiber stripping, stripping pliers fiber optical power meter should be
perpendicular to the direction of the tilt angle, and then use the jaws gently stuck PM, followed by
the right hand forced, along the axial optical power meter Ping introduced to all procedures must
be compact nature. Clean the bare fiber.
The operator must go through rigorous training. First To clean the cutter and adjust the position of
the knife, put the knife to smooth cutting action should be natural, smooth, not heavy, not anxious
to avoid fiber cut, bevel, burrs, cracks and other undesirable end face. Also, learn to "play the
piano" rational allocation and use of his right hand fingers to make specific components
correspond with the cutter, coordination, increase the efficiency of the slice; put a little torn pieces
of cotton, dip a little alcohol (in Pinch two fingers with no overflow is appropriate), folded V
"shaped grip has been stripped overlying fiber optic power meter, power meter along the axial
wipe strive successful, to be replaced after a piece of cotton to use 2 to 3 times, Every time you
want to use different parts and levels of cotton, thereby enhancing the efficiency of cotton, but
also to prevent secondary pollution.