In the following text,we will tell you how to make sublimated fabric lamps with dye sublimation ink and sublimation paper.First of all,download from computer with sublimation transfer paper and printing it into fabric.To begin sewing, lay two pieces with right sides together and pin along one edge. I put pins 3/4 of an inch from either end as markers for where to start and stop sewing. You will need the very top and bottom to remain open so that later you can turn it right side out and fit it over the lamp post. Once the first two pieces are sewn, continue matching piece by piece with like sides together, pinning and sewing until you have made it all the way around the lamp. There will be six seams.

1. Fabric Lamps
Sublimation Printing
With Dye Sublimation
Ink And Sublimation
Paper

2. Recently,I have found an interesteding printing technology and wide
application of it.That is dye sublimation printing,we know dye sub
printing can apply garment,mug,hard material,digital textile
printing,however,to my surprice,sublimation transfer paper can be used
for fabric lamps.

3. In the following text,we will tell you how to make sublimated fabric
lamps with dye sublimation ink and sublimation paper.First of
all,download from computer with sublimation transfer paper and
printing it into fabric.To begin sewing, lay two pieces with right
sides together and pin along one edge. I put pins 3/4 of an inch
from either end as markers for where to start and stop sewing.

4. You will need the very top and bottom to remain open so
that later you can turn it right side out and fit it over the
lamp post. Once the first two pieces are sewn, continue
matching piece by piece with like sides together, pinning
and sewing until you have made it all the way around the
lamp.

5. There will be six seams. Fortunately, these fold up like an
accordion as you move to each new section, so you'll find it
easy to keep extra fabric out of your way while you are
pinning and sewing.The next step is to clip the seams so that
when you turn the "balloon" right side out you will have nice,
smooth seams.

6. Now it's time to assemble your lamp. After screwing 1
nut followed by 1 washer onto one end of the threaded
lamp pipe, stick it into the top of the fence post cap.
Tighten a second nut on the underside of the fence post
cap.Then adhere the 4 vinyl feet to each corner of the
base.

7. This will make the
lamp more stable
and will also create
clearance for the
cord. Once you have
your fabric base
anchored on the
lamp pipe, make
sure that the
stuffing is even and
full. When you are
happy with it, sew
the top closed using
a running stitch in a
circle near the top.
By tightening your
thread, you'll close
the top.

8. In addition,with the washer in place at the top of the lamp, screw on
the base of the light fixture socket. Push the cord up through the base
and out through the socket cap at the top and tie what is called an
underwriter's knot. There are two screws on either side of the socket.

9. Loosen these
screws slightly.
Wrap the ribbed
wire around the
silver screw
and the other
wire around the
brass screw.
Tighten with a
screwdriver.Pul
l the extra wire
back into the
lamp and snap
the socket
down into the
cap and you are
done!?