Decide the location where you will set up car amplifier. Make sure that the location you decide has a good airflow. After confining the position, make purchase of a small fan so as to keep the amplifier cool. Mount the fan so that the air current blows into the amplifier.

1. How to install a car audio amplifier
4/16/2012 How to GPS
Decide the location where you will set up car amplifier. Make sure
that the location you decide has a good airflow. After confining the
position, make purchase of a small fan so as to keep the amplifier
cool. Mount the fan so that the air current blows into the amplifier.
Mount the amplifier to the car after choosing position so that it
does not slide around. The amplifier should come with metal feet for
mounting, If it is not the case, go for any mounting kit available at
most stores. Removal of some upholstery from your car may be required
so that you are able to graft the amplifier to the body for better
securing. After doing that, use a permanent marker to mark where the
legs of your amplifier touch the metal of the car, which will be
served as reminders when you start drilling. Drill holes where you
marked with bits smaller than the width of the screw. Mount your
amplifier and screw it on.
Measure the distance between the amplifier and the car battery and
add a few inches to allow for the route. That measurement is what you
will need to cut the power wire to. Connect one end to the positive
feed of the battery and the other to the positive feed of the
amplifier. Well plan the routings before connection of the two ends.
The wire is required to connect the battery and the amplifier without
in the way.
Wires need to connect with negative feed. Attach one end of the wire
to the negative feed of the amplifier and the other to the car's
chassis. The length of the wire must be short for the purpose of
reducing outside interference, such as a radio broadcast.
Install a final wire, which is also known as the remote-line' and
allows the driver or passenger to turn on or off the amplifier. You

2. can mount an on-off switch for your amplifier in several ways. First
way is to connect it to an external switch with a switch or button
and mount it on the dashboard for easy access. Another way is to
direct wire it to the ignition switches on the inside of the steering
column. The majority of car stereos feature a remote radio output.
You can connect your remote line to the radio output so that the
amplifier only switches on when you turn your car stereo on. Select
your on-off switch you like.
Attach the fan to the remote line so that the fan turns on when the
amplifier powers up.
Connect the speakers to the amplifier after turning to instructions
that come with both the speakers and the amplifier at this point.
You have choices of various car stereos that you can connect your
amplifier to. Browse through the amplifier manual for the best way to
install car stereos.
Now you have access to music of excellent sound and quality. Have
fun!
You May Also Like
• How to Mount GPS in car
• Car Subwoofer buying guide
• Car Speaker Buying Guide
• Car DVD GPS Installation Guide
• Car Stereo Buying Guide
Created by:Oem car gps
Oemcargps.com,Offer Oem Fit Aftermarket Car GPS,Car DVD,Car Stereo for All Car
Make Wholesale.