SHRI VAISHNAV INSTITUTE OF TECHNOLOGY & SCIENCE, INDORE                         2ND Mid SEM TesT July 2010                ...
Upcoming SlideShare
Loading in …5
×

Eg o31

347 views

Published on

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
347
On SlideShare
0
From Embeds
0
Number of Embeds
3
Actions
Shares
0
Downloads
1
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Eg o31

  1. 1. SHRI VAISHNAV INSTITUTE OF TECHNOLOGY & SCIENCE, INDORE 2ND Mid SEM TesT July 2010 Engineering Graphics (BE-105) (EI, TX, CS, CE Branches)Duration :1½ Max. Marks: 20Attempt any four questions. Each questions carry equal marks.Q.-1 The top view of a line AB, 60mm long, measures 40mm. Its end A is 40mm in front of VP and 12mm above the HP. End B is 12mm in front of the VP and is below the HP. Draw its plan and elevation and determine its inclinations with the HP and VP. Also locate its traces.Q.-2. Draw projection of a pentagonal lamina of 30 mm side, is resting on H.P. on one of its corner which is 48 mm away from V.P., such that its plane is inclined to the H.P. at 60º. The edge opposite to the corner is parallel to the H.P. and makes an angle of 45º with V.P.Q-3. A square pyramid, 40 mm base sides and axis 60 mm long, has a triangular face on the ground and the vertical plane containing the axis makes an angle of 450 with the VP. Draw its projections. When the apex is nearer to VP.Q.-4. A Hexagonal prim of 25 mm sideQ-.5. A pentagonal prism, 30 mm base side & 50 mm axis is standing on Hp on its base with one side of the base perpendicular to VP. It is cut by a section plane inclined at 40º to the HP, through mid point of axis. Draw Fv, sectional Top View and Sectional Side View. Also draw true shape of section and Development of surface of remaining solid.Q.-6. A square pyramid of 30 mm base sides and 50 mm long axis is centrally placed on the top of a cube of 50 mm long edges. Draw isometric view of the pair.Q.-7. Attempt any four of the following. a. Name various software’s used for CAD? b. What are limitations of CAD? c. What are main components of CAD? d. Write any five edit commands used in CAD? e. Write any five commands used for dimensioning in CAD?

×