Ellesmere college task 3 presentation

520 views

Published on

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
520
On SlideShare
0
From Embeds
0
Number of Embeds
9
Actions
Shares
0
Downloads
2
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Ellesmere college task 3 presentation

  1. 1. Cantatech Extended Thinkers Task 3 Spaghetti, Marshmallow, Potato Structure Ellesmere College
  2. 2. Trial and Error
  3. 3. Making our Structure We made our structure in 4 parts. Part 1 – Making the Base Part 2 – Making the Top Part 3 – Connecting the Top and Base Part 4 - Reinforcing
  4. 4. Part 1 - MAKING THE BASE 1. Place 4 marshmallows 10cm apart to make a square. 1. Join the marshmallows with ½ lengths of spaghetti. 1. Place a marshmallow in the middle and join it diagonally with ½ lengths of spaghetti.
  5. 5. Part 1 - MAKING THE BASE 4. Use 4 full lengths of spaghetti and poke them into each marshmallow extending upwards. 5. Join the tall pieces with a marshmallow at the top.
  6. 6. Part 1 - MAKING THE BASE 6. Repeat steps 1-4 to make another 3 towers. 7. Join together to make a square. Connect together. 8. Connect the middle marshmallows together and also the top pieces. 9. Criss-cross the top and bottom marshmallows diagonally.
  7. 7. Part 2 - MAKING THE TOP 1. Follow steps 1 and 2 as per base. 2. Use 4 full lengths of spaghetti and poke them into each marshmallow extending upwards. 3. Join the tall pieces with a marshmallow.
  8. 8. Part 2 - MAKING THE TOP 4. Push down the top marshmallow so it is a third down. 5. Attach a ½ marshmallow onto each length of spaghetti.
  9. 9. Part 2 - MAKING THE TOP 6. Break one length of spaghetti into quarters. 7. Use each piece to attach the marshmallow at the spaghetti ends. 8. Repeat steps 6-7, but snap full lengths into halves. 9. Make another square and attach to the square underneath. This builds the potato platform. 10.Reinforce the middle parts by criss-crossing
  10. 10. Part 3 – CONNECTING TOP and BASE 1. Snap one length of spaghetti into eighths. 2. Put them into the top marshmallows on the base. 3. Place the top into these stalks connecting the top and base together.
  11. 11. Part 4 – REINFORCING 1. Place the potato onto the top platform to test the strength of the structure. 2. If not strong enough reinforce where weaknesses show. 3. If starting to lean build a triangular structure to the side to stabilise. 4. Keep putting the potato onto the platform to check. 1. GOOD LUCK
  12. 12. Our Potato Holding Structure…
  13. 13. The NEW Challenge How far will the potato roll off a ramp?
  14. 14. Our Prototype… Oops it collapsed just as the photo was taken!!
  15. 15. Task 3 Team Members – Ellesmere College •Kambel Ratapu •Abby Birkett •Leah Hill Thanks •Thomas Wright we had •Caleb Moffatt FUN! •Gunther Burnett-Christensen

×