We are doing latest IEEE 2011 Power Electronics Hardware...Any hardware @ very very low cost..Contact: 9487 617 617, Mail: pelstech@gmail.com, web: www.peprojects.tk
Beginners Guide to TikTok for Search - Rachel Pearson - We are Tilt __ Bright...
Final Year Projects 2011@PELS TECH-Sathyamangalam
1. PELS TECH
POWER ELECTRONICS TECHNOLOGY
POWER ELECTRONICS
BOOST CONVERTER
1 Analysis, design and experimental results of a floating-o utput interleaved-input boost-
derived DC – DC high-gain transformer-less converter
2 Average current controlled switching regulators with cascade boost converters
3 Closed-Loop Analysis and Cascade Control of a Nonminimum Phase Boost Converter
4 Analysis, Design, and Experimentation of an Isolated ZVT Boost Converter With
Coupled Inductors
5 An Efficient High-Step-Up I nterleave d DC–DC Converter With a Common Active
Clamp
BOOST RECTIFIER
6 Three–leg power converter topology for a battery charger
7 A Multicarrier Pulse Width Modulator for the Auxiliary Converter and the Diode
Rectifier
8 EMI Filter Design for a 1 MHz, 10 kW Three-Phase/Level PWM Rectifier
9 A Three-Phase Unity Power Factor Single-Stage AC–DC Converter Based on an
Interleaved Flyback Topology
BUCK CONVERTER
10 Synchronous Buck Converter based PV Energy System for Portable Applications
11 Comparative study of Proportional Integral and Backstepping Controller for Buck
Converter
12 A Novel Control Scheme of Synchronous Buck Converter for ZVS in Light-Load
Condition
13 Inherent clamp flyback – buck converter with windin g cross-co upled inductors
14 New Approach for MPPT Control of Photovoltaic System With Mutative-Scale Dual-
Carrier Chaotic Search
15 Dynamic Characteristics of Current-Fed Superbuck Converter
DC DC CONVERTER
16 Switched-coupled inductor cell for DC – D C converters with very large conversion
ratio
17 Li-ion battery charger based on digitally controlled phase-shifted full-bridge converter
18 Small signal analysi s and closed loop control design of active- clamped ze ro-volta ge
switched two inductor current-fed isolated DC – D C converter
19 Multiphase DC–DC Converters Using a Boost-Half-Bridge Cell for High-Voltage and
High-Power Applications
MULTILEVEL INVERTER
20 Multilevel inverters for low-power application
21 Generalised pulse width modulation approach for DC capacitor voltage balancin g in
diode-clamped multilev el converters
22 A Hybrid Cascade Conve rter Topology With Series-Connected Symmetrical and
Asymmetrical Diode-Clamped H-Bridge Cells
2nd Floor, NSR New Complex, Opp Anush Hospital, Sathyamangalam-2
Contact: 9487 617 617, Mail: pelstech@gmail.com, web: www.peprojects.tk
2. PELS TECH
POWER ELECTRONICS TECHNOLOGY
POWER FACTOR CORRECTION
23 Design Considerations of Soft Switched Buck PFC Converter with Constant On-Time
(COT) Control
24 Bridgeless High-Power-Factor Buck Converter
POWER SYSTEM
25 An Islanding Detection Method for a Grid-Connected System Based on the Goertzel
Algorithm
26 High-Performance Adaptive Perturb and Observe MPPT Technique for Photovoltaic-
Based Microgrids
27 Interleaved Soft-Switching Boost Converter for Photovoltaic Power-Generation System
28 Multicascoded Sources for a High-Efficiency Fuel-Cell Hybrid Power System in High-
Voltage Application
29 High-Efficiency MOSFET Inverter with H6-Type Configuration for Photovoltaic
Nonisolated AC-Module Applications
30 A Modular Grid-Connected Photovoltaic Generation System Based on DC Bus
31 A High-Efficiency Grid-Tie Battery Energy Storage System
32 A Novel High Step-Up DC–DC Converter for a Microgrid System
RESONANT INVERTER
33 Analysis of two resonant converters with the same converter leg
34 Series resonant inverter with selective harmonic operation applied to all-metal domestic
induction heating
2nd Floor, NSR New Complex, Opp Anush Hospital, Sathyamangalam-2
Contact: 9487 617 617, Mail: pelstech@gmail.com, web: www.peprojects.tk