Successfully reported this slideshow.
Your SlideShare is downloading. ×

2018 08 quickguide_power_meter_en

2018 08 quickguide_power_meter_en

Download to read offline

CÔNG TY ANH EM, NHA KHOA, MORITA DENTAL, ĐIỀU TRỊ LASER, ghế răng, nội nha, trị tủy mài cùi, thẩm mỹ, phục hình, implant nha khoa,

CÔNG TY ANH EM, NHA KHOA, MORITA DENTAL, ĐIỀU TRỊ LASER, ghế răng, nội nha, trị tủy mài cùi, thẩm mỹ, phục hình, implant nha khoa,

More Related Content

Related Books

Free with a 30 day trial from Scribd

See all

Related Audiobooks

Free with a 30 day trial from Scribd

See all

2018 08 quickguide_power_meter_en

  1. 1. 1 | 4info@arclaser.com FOX www.arclaser.com Quick Guide power meter
  2. 2. 2 | 4info@arclaser.com FOX www.arclaser.com 2 1b 1a 4 3 Quick Guide power meter power calibration 1. start laser 2. set desired power on the display 3. connect power meter to FOX Laser Attention: Wavelength of laser and power meter must match! - connect cable to power meter (1a) - connect other side of the cable with FOX AUX 3 port (1b) 4. Put bare fiber into laser fiber port (2) 5. Insert the fiber into surgery handpiece and connect it with the power meter (3) - overlap of the fiber to the handpiece should be between 3 and 5 mm 6. press the ready button (4) to set laser to ready mode
  3. 3. 3 | 4info@arclaser.com FOX www.arclaser.com 5 6 7 Quick Guide power meter power calibration 7. Press and hold the foot switch c blue screen change - gray field (5): Display of the set power - blue field (6): power output at fiber end 8. Simultaneously pressing the two arrow keys (7) and the foot switch saves the measured value (if the measured value is outside the tolerance, the measured value is not saved)
  4. 4. 4 | 4info@arclaser.com FOX www.arclaser.com 8 10 9 11 Quick Guide power meter power calibration 9. The display now shows the measured value (8) 10. Now the calibration is completed. The power meter can be seperated from the FOX 11. Back to main laser screen (9) - yellow value (10) displays the measured output power at the end of bare fiber - black value (11) Display of the set power 12. To set the desired power for the applicati- on, the ‚+‘ and ‚-‘ buttons can be used as usual. The power changes affects the actual measured value. Attention: The stored settings are cleared as soon as the fiber is pulled out of the laser!

×