Aircrack windows web

2,573 views

Published on

0 Comments
1 Like
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total views
2,573
On SlideShare
0
From Embeds
0
Number of Embeds
3
Actions
Shares
0
Downloads
33
Comments
0
Likes
1
Embeds 0
No embeds

No notes for slide

Aircrack windows web

  1. 1. Crack WEP networks with Commview and Aircrack-ngTools Needed :1) Commview for Wifi2) Aircrack-ngInstructions :1) Download, Install and open Commview for wifi.2) Click on the “Blue play button” and the screen shown below will appear. Click on the “StartScanning” button. 1
  2. 2. 3) Now as all the available networks start to load, look for your target. Click on your targetnetwork (Make sure its WEP) and proceed to press the “Capture” button. (Shown Below) 2
  3. 3. 4) Now you will see the screen shown below as they collect packets. I have read tutorialsclaiming that a minimum of 5000 packets is needed. But in my experience, iv had to collect atleast 15,000 packets before successfully cracking it.Note : The packets are secondary, What is actually happening here is that we are trying tocollect as much IVs (Initialization vector) from those retrieved packets. The more IVs collectedthe higher the chance of cracking it. So if you collected 5000 packets but have shit loads of IVs inthem, Then that is all you will need. But if the IVs is limited then you might have to go for 15,000 3
  4. 4. +++++++ packets. Do the Math.5) Now that i have collected around 50,000 packets, i proceed to click on the “blue stop button.”Next click on the “Logging” tab to check where the packets were saved on your hard drive. In mycase its saved on my desktop. Or if you prefer in the future do this setting before starting.(Shown Below)6) Now minimize Commview and locate the logged packets on your hard drive. Once you havefound it, double click on it and a screen will appear. Click “File”, “Save as” and change the outputfile to “WireShark/TCPDump” and press save.7) Now lets proceed to “aircrack-ng.zip” and unzip the folder to your desktop. 4
  5. 5. 8) Double click on the extracted folder and locate the bin folder within.9) Once you are inside the bin folder, locate the file Aircrack-ng-GUI.exe and double click on it.The screen shown below will appear.10) Click on the “Choose Button” and direct it to your Wireshark file that you just saved aminute ago.11) Lets keep the Encryption type to “WEP”.12) Key Size : 12813) Now proceed to press on the launch button. A command prompt will appear, allow it to fullyload .14) Index number of target network? In my case i key in 1 and press enter.15) The screen shown below will appear, sit back and wait for it to do its magic. And before youknow it! Voila! 5
  6. 6. Congratulations! We have successfully cracked the WEP password !Contributed ByJames (www.jameslovecomputers.wordpress.com) 6

×