Successfully reported this slideshow.
We use your LinkedIn profile and activity data to personalize ads and to show you more relevant ads. You can change your ad preferences anytime.

Cold Caustic Process of Nanocoating Copper Wire

7,517 views

Published on

Learn step by step how to nanocoat copper wire for keshe technology. More info at http://keshefoundation.org/

Published in: Education
  • Be the first to comment

Cold Caustic Process of Nanocoating Copper Wire

  1. 1. COLD CAUSTIC NANOCOATING COPPER WIRE
  2. 2. 2.1 Gather Materials wire stripper, vinyl gloves, safety goggles, coca cola bottle, cold caustic liquid, 14 awg wire or smaller
  3. 3. Have a spray bottle of vinegar for safety. If caustic gets on your skin spray vinegar on the area
  4. 4. Purchase bare copper wire will make the job easier. Size 14 awg wire or smaller
  5. 5. If you can only locate coated wire, The Klein Tools - Katapult Wire Stripper/Cutter will make this task MUCH easier
  6. 6. 2.2 Measure approximately 4 inches of wire and cut
  7. 7. 2.3 Repeat for several wires
  8. 8. 2.4 Strip wires if necessary
  9. 9. 2.5 Use pliers to bend the end of the wire back towards itself
  10. 10. Notice that the end of the wire is NOT touching itself
  11. 11. 2.6 Bend the bottom wire in the opposite direction
  12. 12. Notice the edge of the wire is directly pointing back at the body of the wire. The edge cannot be seen from behind.
  13. 13. 2.7 Repeat for all of the wires
  14. 14. 2.8 Put on your safety gear
  15. 15. 2.9 Open your Coca Cola bottle
  16. 16. 2.10 Place your wire in the Coca Cola bottle
  17. 17. 2.11 Repeat for all wires
  18. 18. 2.12 Shake up the contents of the cold caustic liquid
  19. 19. 2.13 Check the sprayer nozzle to verify it is open
  20. 20. 2.14 Spray several times into the bottle
  21. 21. 2.15 Replace cap onto the bottle
  22. 22. 2.16 Shake the bottle to allow liquid to coat the copper
  23. 23. 2.17 Carefully pour the excess liquid back into the sprayer bottle
  24. 24. 2.18 Replace Cap and shake bottle
  25. 25. 2.19 Rest bottle at an angle to allow excess liquid to collect away from the copper
  26. 26. 2.20 Note the time. Wait 6 hours
  27. 27. 2.21 Shake the bottle 2.22 Pour off excess liquid back into spray bottle 2.23 Set bottle down at an angle
  28. 28. 2.24 Let the bottle sit overnight
  29. 29. 2.25 Open the Bottle
  30. 30. 2.26 Set Nano Coated Wires out on a towel to dry. Always use Gloves When Handling NanoMaterials
  31. 31. 2.27 Pour any remaining liquid into the spray bottle
  32. 32. 2.28 Label Your Coca Cola Bottle For safety and reuse

×