Monoblock– close coupled pump sets

504 views

Published on

coupled pumpsets, borewell submersible pumpsets, end suction pumps, monoblock coupled pumpsets, multistage vertical pumps, inline pumps, openwell submersible enblock pump sets

Published in: Business
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
504
On SlideShare
0
From Embeds
0
Number of Embeds
8
Actions
Shares
0
Downloads
2
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Monoblock– close coupled pump sets

  1. 1. Monobloc– Close Coupled Pump sets SAER Monobloc Pumps are designed and manufactured for optimum efficiency to cater to different needs of water handling. The pump range is suitable for a wide range of applications in Commercial, Industrial areas, domestic Applications. SAER mono bloc pumps are available in various series depending on applications requirements, like pump couple with motor, stub shaft pumps ETC. CLOSE COUPLED ELECTRIC PUMPS Operation Condition:Max Head : 100 M (328 ft) Max Capacity : 400 m3/hr Temp of Pumped Liquid : -15oC to 120oC Frequency : 50 Hz Rpm : 2900 Sucking DN : 50 to 100 mm DN capacity : 32 to 80 mm Pumps Construction:Pump body with dimension and performances according to EN 733 rules, closed impeller dynamically balanced and with balance holes for the balancing of the axial thrust. Shaft completely in stainless steel, greased ball bearings, flanges (UNI EN 1092-2): up to DN 150: PN16, from DN 200:PN10. APPLICATIONS Recycling plants Heating, air conditioning Heat recovery Plants of water supply procurement, Pressurizing units Fire-fighting systems.
  2. 2. Centrifugal pumps with Stub Shaft Operation Condition:Max Head : 102 M (334ft) Max Capacity : 255 m3/hr Temp of Pumped Liquid : -15oC to 120oC Frequency : 50 Hz Rpm : 2900 Sucking DN : 50 to 100 mm DN capacity : 32 to 80 mm Pumps Construction:MG1-MG2 electro pumps are of the single-impeller, single-block centrifugal type with rigid coupling, coupled to a standard B3/B5 form asynchronous motor. MG1: bare shaft pump, MG2: pump with motor. The coupling is obtained by means of a block with ball bearing on which the pump shaft is secured and integrated with a rigid coupling. The motor unit and the rotating part of the pump can be taken away without removing the pump body from the system piping. APPLICATIONS Recycling plants Heating, air conditioning Heat recovery Plants of water supply procurement, Pressurizing units
  3. 3. Fire-fighting systems. SPECIAL VERSIONS Constructive materials Different mechanical seals Mechanical seal normalized according to UNI EN 12756 If you Want to More Information Please visit our website:-http://www.emerge-india.com

×