Cemaric Heating Element For Solar Water Heater, Hard Water Qyality

86 views

Published on

Published in: Technology
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
86
On SlideShare
0
From Embeds
0
Number of Embeds
2
Actions
Shares
0
Downloads
1
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Cemaric Heating Element For Solar Water Heater, Hard Water Qyality

  1. 1.   1   Ceramic Heater Specially Designed For Solar Water Heater Suitable For: A: Instant Hot Water Tap, Traditional Electrical Water Heater, Storage Water Heater, Boiling Water Heater, Water Dispenser, Coffee Machine, Beverage Dispenser and House/Apartment/Hotel Water Heating Solution. B: Industry Boiler, Electric Heating, Electrolyte Heating Source etc. Features: 1. Guaranteed Safety: Heating wire will be oxidized immediately when the ceramic is broken. producing leakage current much lower than body safety value: ( 10 mA) 2. High Energy Efficiency: With high thermal conductivity ceramic, higher energy efficiency was achieved compared with traditional heater. 3. Corrosion Resisting: No need for corrosive-resistant coating, silicon nitride ceramic has excellent anti-acid/alkali properties, never rust. 4. Fast Circulating: High power was concentrated in a small ceramic heater, and circulating of water in the tank was accelerated, results in uniform temperature distribution. 5. Anti Incrustation Scale:
  2. 2.   2   The ceramic surface was well polished, avoiding scale adhesion. 6. Intelligent temperature Control: Integrated temperature control device was used to control the heater according to water-temperature automatically. No intervention needed.Models: Item No. Heating Size Install Hole Power Joint Connector A1 85*17*4mm 17*4mm 2000-2500W 1” 1.25” 1.5” A2 85*17*4mm 17*4mm 200-800W 1” 1.25” 1.5” B1 73*30*4mm 30*4mm 2500-3500W 1” 1.25” 1.5” C1 60*17*4mm 17*4mm 1500-2000W 1” 1.25” 1.5” D1 102*24*4mm 24*4mm 3000-3800W 1” 1.25” 1.5” Technical Parameters: Rated Voltage AC 220/110V 50/60HZ Rated Power: 200-3800W Insulation Electric Strength: No breakdown in 60s under 2500V/50HZ Leakage Current: < 0.025 mA in normal condition, < 10mA after breakdown Use of media: Water, Acid and alkali solution, Air, Oils, Organic solvents, Gas, etc. Volume Density 3.2-3.3g/cm3 Fracture Toughness 5.0-8.0 MPa*m 1/2 Room Temperature Strength Resistance > 900MPa High Temperature Strength Resistance > 700MPa Vickers Hardness 15-20GPa Relative Dielectric Constant 6-7 Volume Resistivity 10^14 Ω·cm Thermal Conductivity 20-50W(m*K) Thermal Expansion Coefficient 3.0*10-6/K

×