ECWAY TECHNOLOGIES IEEE PROJECTS,HARDWARE & SOFTWARE DEVELOPMENTS OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE BANGALORE / HYDRABAD CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111 Mail to: ecwaytechnologies@gmail.com | ecwayembedded@gmail.com VISIT: www.ecwaytechnologies.com | www.ecwayprojects.com

1. ECWAY TECHNOLOGIES
IEEE PROJECTS & SOFTWARE DEVELOPMENTS
OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE
BANGALORE / HYDRABAD
CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111
VISIT: www.ecwaytechnologies.com | www.ecwayprojects.com
Mail to: ecwaytechnologies@gmail.com | ecwayembedded@gmail.com
FABRICATION OF TEMPERATURE MONITORING
SYSTEM IN CUTTING TOOL WITH COOLANT
CIRCULATING SYSTEM
SYNOPSIS
A coolant is a fluid which flows through a device to prevent its
overheating, transferring the heat produced by the device to other devices
that use or dissipate it. An ideal coolant has high thermal capacity, low
viscosity, is low-cost, non-toxic, and chemically inert, neither causing nor
promoting corrosion of the cooling system
The most common coolant is water. Its high heat capacity and low
cost makes it a suitable heat-transfer medium. It is usually used with
additives, like corrosion inhibitors and antifreeze. Antifreeze, a solution of a
suitable organic chemical (most often ethylene glycol, diethyl glycol, or
propylene glycol) in water, is used when the water-based coolant has to
withstand temperatures below 0 °C, or when its boiling point has to be raised
In our project temperature monitoring system in cutting tool is
monitored by a sensor which is placed in a tool post, when temperature
increased from the specified rate ,automatically pump starts and supply the
coolant to lathe, this circulation system is fully monitored by control system,
when temperature decreases pump will automatically switched off

2. CONTROLUNIT
Fabricationoftemperaturemonitoringsystemincutting
toolwithcoolantcirculatingsystem
COOLANTPUMP
COOLANTLINE
COOLANT
NOZZLE
PLATFORM
TANK
LATHECHUCK
JOB
TEMPSENSINGUNIT
TOOL
Advantage
1) constant temperature is maintain in tool
2) coolant wastage is avoided
3) pump can be start automatically
Disadvantage
1) System is closed loop so maintenance is tough